Go Back   Club Lexus Forums > Search Forums
Sign in using an external account
Register Forgot Password?

Showing results 1 to 25 of 495
Search took 0.50 seconds.
Search: Posts Made By: ibidu1
Forum: GS - Third Generation Yesterday, 11:00 AM
Replies: 6
Views: 329
Posted By ibidu1
I have the same problem in my rear tires, still...

I have the same problem in my rear tires, still unable to find the problem. They cup and feather the insides.

One member suggest lower front control arm bushings.
Forum: GS - Third Generation Yesterday, 10:56 AM
Replies: 8
Views: 209
Posted By ibidu1
Priced to high imo

Priced to high imo
Forum: GS - Third Generation 05-28-15, 01:16 AM
Replies: 18
Views: 776
Posted By ibidu1
Im sure it will to a point, of getting the right...

Im sure it will to a point, of getting the right angle on the axles. If you are seriously lowered im sure the spacer would need to be thicker to compensate for the angles.
Forum: GS - Third Generation 05-26-15, 04:40 PM
Replies: 1
Views: 120
Posted By ibidu1
Inspect the water pump for leaks, other then that...

Inspect the water pump for leaks, other then that I dont see any other concern
Forum: GS - Third Generation 05-25-15, 04:13 AM
Replies: 10
Views: 349
Posted By ibidu1
You must remove the caliper from the car, you...

You must remove the caliper from the car, you will need to undo the brake line then later bleed that caliper.

To free up the caliper, youll will need to spray wd40 into the pin area and let it...
Forum: GS - Third Generation 05-23-15, 03:00 AM
Replies: 10
Views: 349
Posted By ibidu1
The hex bolts hold the caliper holding bracket,...

The hex bolts hold the caliper holding bracket, the caliper floats on a lower pin. That pin usually seizes up not allowing the caliper to return to its starting position.

Using heat to heat the...
Forum: GS - Third Generation 05-23-15, 02:36 AM
Replies: 18
Views: 776
Posted By ibidu1
Was it a pain to install? How long did it take you

Was it a pain to install? How long did it take you
Forum: GS - Third Generation 05-22-15, 05:06 AM
Replies: 10
Views: 349
Posted By ibidu1
Do you have a propane torch? If so heat the stock...

Do you have a propane torch? If so heat the stock caliper and break it loose with a hammer. Ive done 4 already all successfully
Forum: GS - Third Generation 05-21-15, 11:11 AM
Replies: 8
Views: 404
Posted By ibidu1
I would replace water pump and flush the cooling...

I would replace water pump and flush the cooling system, 2007 are great with no known issues. But its AWD if you wanted to lower it, you will get vibrations.

Also in 2008 they updated the 3GS...
Forum: Suspension 05-18-15, 01:21 PM
Replies: 10
Views: 448
Posted By ibidu1
I run 20's with a 20mm rca, currently my tires do...

I run 20's with a 20mm rca, currently my tires do rub. My old tires did not, it all matters on the tires. If you run square edged tires you will rub. You will need to do fender liner trimming, and...
Forum: GS - Third Generation 05-18-15, 01:02 PM
Replies: 18
Views: 776
Posted By ibidu1
Awesome, im glad someone is making something...

Awesome, im glad someone is making something positive. I think this may help the vibes.
Forum: Suspension 05-12-15, 12:15 PM
Replies: 3
Views: 274
Posted By ibidu1
I had the same issue with stock wheels and tires....

I had the same issue with stock wheels and tires.

I have though about adding more positive rear camber. I will take it to the alignment shop again and see what we can.

I have been rotating...
Forum: GS - Third Generation 05-12-15, 11:00 AM
Replies: 2
Views: 225
Posted By ibidu1
Hey Designo, 8.5 front 10.5 rear 245/35/20...

Hey Designo,

8.5 front 10.5 rear 245/35/20 275/30/20

Stock wheels and tires, before this set had the same wear pattern. Its like half the tire forms a wave. From that my tires are starting to...
Forum: GS - Third Generation 05-11-15, 10:42 PM
Replies: 2
Views: 225
Posted By ibidu1
Rear tire wear GS350

Hey guys on my 08 GS350 AWD with staggered 20's and stock ride height. Ive been having rear tire wear for the longest time. I cannot seem to track down the problem.

Many alignment shops have...
Forum: Suspension 05-10-15, 01:28 AM
Replies: 6
Views: 372
Posted By ibidu1
KYB's are the stock exact shocks! Even the old...

KYB's are the stock exact shocks! Even the old OEM say KYB on them. Ive replaced my rears and put them side by side no difference.
Forum: Suspension 05-10-15, 12:04 AM
Replies: 3
Views: 274
Posted By ibidu1
Rear tire wear GS350

Hey guys on my 08 GS350 AWD with staggered 20's and stock ride height. Ive been having rear tire wear for the longest time. I cannot seem to track down the problem.

Many alignment shops have...
Forum: GS - Third Generation 02-10-15, 06:50 AM
Replies: 43
Views: 2,532
Posted By ibidu1
Take it to the dealer do a full inspection, if...

Take it to the dealer do a full inspection, if transmission is at fault or any issues. Return the car to the seller, if not sue for money. Also I would look on clublexus.com pull the history of the...
Forum: GS - Third Generation 02-07-15, 01:59 AM
Replies: 12
Views: 1,021
Posted By ibidu1
An AWD would stand a little bit higher in the...

An AWD would stand a little bit higher in the front due to having beefier lower ball joints then RWD. The difference is maybe 10mm.

RCA will not help cure whobble's and vibrations in the front....
Forum: GS - Third Generation 02-03-15, 12:51 PM
Replies: 7
Views: 916
Posted By ibidu1
Wald also have a similar wing for 4gs ...

Wald also have a similar wing for 4gs

http://lexusenthusiast.com/images/gallery/gallery-lexus-gs-wald-international-executive-new/grl10_m_03.jpg
Forum: GS - Third Generation 02-03-15, 12:48 PM
Replies: 7
Views: 916
Posted By ibidu1
Ya that looks custom Look up a wald rear...

Ya that looks custom

Look up a wald rear spoiler for a LEXUS IS250 06-13

Its kind of close but more subtle, fiberglass replicas can be found on ebay for cheap. Maybe you can buy one cut it in...
Forum: GS - Third Generation 02-01-15, 12:02 PM
Replies: 6
Views: 398
Posted By ibidu1
Use a needle nose pliers instead of the fuse...

Use a needle nose pliers instead of the fuse puller its much faster

As far as the trunk not operating theres a TSB for the fuse panel in the driver side, I believe the connections get corroded.
Forum: GS - Third Generation 01-28-15, 06:27 AM
Replies: 2
Views: 327
Posted By ibidu1
Maybe your coil overs are blown, or maybe you...

Maybe your coil overs are blown, or maybe you have a bent rim or the rims not balanced properly.

If you have a 2wd mount the front wheels to the rear and do a burn out that should help round them...
Forum: GS - Third Generation 01-26-15, 01:00 AM
Replies: 4
Views: 463
Posted By ibidu1
Sounds like you may have popped the main fuseable...

Sounds like you may have popped the main fuseable link

Whats the voltage coming out of the battery?
Forum: GS - Third Generation 01-26-15, 12:57 AM
Replies: 12
Views: 562
Posted By ibidu1
Ive owned tanned interior lexus, I like tan mats...

Ive owned tanned interior lexus, I like tan mats aslong as your a clean freak like me. If not go for black because tan mats you have to shampoo them often as black just vacuum. Tan mats look better...
Forum: GS - Third Generation 01-18-15, 06:51 AM
Replies: 2
Views: 267
Posted By ibidu1
List it on craigslist im sure it will sell for...

List it on craigslist im sure it will sell for atleast half of what you paid for it. I believe AWD also fits AWD is250's
Showing results 1 to 25 of 495

 
Forum Jump
All times are GMT -7. The time now is 05:09 PM.

Join ClubLexus

Copyright © 2000-2015 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS


Get all contact info