Go Back   Club Lexus Forums > Search Forums
Sign in using an external account
Register Forgot Password?

Showing results 1 to 25 of 500
Search took 0.61 seconds.
Search: Posts Made By: salimshah
Forum: RX350 / 330/ 300 / 400H / 450H Classifieds Yesterday, 12:02 AM
Replies: 0
Views: 55
Posted By salimshah
FS '99 OEM Spoiler - $50

I will detach and mail out the spoiler so you will have to figure out how to attach it. Any thing that comes off will be mailed. Anything that remains attached to the hatch stays.

Color Golden...
Forum: RX - First Generation 03-28-15, 11:42 PM
Replies: 27
Sticky: Pay it Forward
Views: 5,400
Posted By salimshah
Rear Hatch parts

I have 99 RX rear hatch parts.

Trim: Taupe
Body Golden Pearl (white for 99 & 00)

Missing:
Large Two pieces (interior)

Available:
Top and side trim (clips may be missing)
Forum: RX - First Generation 03-28-15, 11:06 PM
Replies: 3
Views: 102
Posted By salimshah
Gas lid trouble. Please check yours

I almost got into trouble today. Luckily, wife was with me and with her assistance we dodged the bullet.

Drove up to a gas pump and pulled the release, but the lid did not pop open. Did that...
Forum: RX - First Generation 03-28-15, 10:56 PM
Replies: 6
Views: 241
Posted By salimshah
Can you elaborate? Did you take out the...

Can you elaborate?

Did you take out the wheel side of the shaft and swung away the hub? You are then supposed to remove the bearing lock bolt and the snap ring.

Invest in the service manual if...
Forum: RX - First Generation 03-28-15, 07:06 AM
Replies: 4
Views: 105
Posted By salimshah
You need two people to narrow it down... one...

You need two people to narrow it down... one starting and one looking in the engine bay.

There are two belts which can make the screeching sound, but it is not grinding. You can mist the belts...
Forum: Performance & Maintenance 03-27-15, 06:45 PM
Replies: 1
Views: 128
Posted By salimshah
Tool to hold the main pulley to undo and torque...

Tool to hold the main pulley to undo and torque the bolt at the end.
Tool to pull the pulley off the crankshaft.
Stud remover for water pump.
Seal removing tool (paint can opener is a good...
Forum: RX - First Generation 03-26-15, 12:41 PM
Replies: 39
Views: 39,662
Posted By salimshah
Generally never, but most likely you will...

Generally never, but most likely you will encounter an event that requires replacing it. That event can be pump going bad or rack developing a leak. If you notice the fluid to be dark, then gradually...
Forum: RX - First Generation 03-25-15, 08:35 PM
Replies: 8
Views: 159
Posted By salimshah
Yes, those are the seals I am talking about. It...

Yes, those are the seals I am talking about. It is also recommended to replace the the lock/snap that goes on the end of the shaft and locks the shaft in the transmission [Please check the notes as...
Forum: RX - First Generation 03-25-15, 08:12 PM
Replies: 2
Views: 132
Posted By salimshah
Welcome to CL. A prerequisite to posting is...

Welcome to CL.

A prerequisite to posting is to go through the sticky threads and doing a search. :^)

Your problem is related to mode or mix servo (most likely the mode servo). There is a DIY.
...
Forum: RX - First Generation 03-25-15, 04:10 PM
Replies: 17
Views: 6,175
Posted By salimshah
I dont think there is a 99 Highlander Salim

I dont think there is a 99 Highlander

Salim
Forum: RX - First Generation 03-25-15, 06:52 AM
Replies: 8
Views: 159
Posted By salimshah
Add transmission output seals. Salim

Add transmission output seals.

Salim
Forum: RX - First Generation 03-23-15, 11:18 PM
Replies: 2
Views: 124
Posted By salimshah
Welcome to CL. The title should be less...

Welcome to CL.

The title should be less vague and should give some clue to your problem.

Imobolizer can prevent spark. Pinched wire or disconnected ground, or a loose/un-connected connector can...
Forum: RX - First Generation 03-23-15, 10:54 AM
Replies: 29
Views: 775
Posted By salimshah
This has been my favorite explanation ,,, At...

This has been my favorite explanation ,,, At high speeds thee oil pump is delivering lots of oil and gravity is working the oil down .. the restriction in oil channels in preventing the drop down...
Forum: RX - First Generation 03-23-15, 07:24 AM
Replies: 8
Views: 883
Posted By salimshah
If you have an OEM pan, the surface is smooth....

If you have an OEM pan, the surface is smooth. Some one used rtv as added insurance to prevent leak and there is a good chance that the crush washer was re-used.

Lightly oil both surfaces of the...
Forum: RX - First Generation 03-21-15, 06:55 PM
Replies: 15
Views: 4,458
Posted By salimshah
Welcome to CL. Please read the sticky...

Welcome to CL.

Please read the sticky threads .. specially .. having problems, start here thread. Look up on IACV.

Salim
Forum: RX - First Generation 03-20-15, 02:12 PM
Replies: 22
Views: 709
Posted By salimshah
RX got a larger tank and tighter turning radius...

RX got a larger tank and tighter turning radius but not the initial RX.

My guess is about 15 gallons.

Keep the tank 1/4 full at minimum. Concentration of sediments gets higher and the fuel pump...
Forum: Suspension and Brakes 03-19-15, 08:44 PM
Replies: 58
Views: 105,713
Posted By salimshah
Additional tip: The steering shaft has a...

Additional tip:

The steering shaft has a short connecting piece with 12mm bolts. Loosen the bolt near the firewall and remove the other bolt which is at the rack end. Slide the connecting rod up...
Forum: RX - First Generation 03-18-15, 10:27 PM
Replies: 8
Views: 273
Posted By salimshah
Welcome to Club Lexus. Can you shed some...

Welcome to Club Lexus.

Can you shed some light on prior history of maintenance, specifically oil change with quality oil?

Please never put property above personal safety. My advice to lady...
Forum: RX - First Generation 03-18-15, 07:23 AM
Replies: 7
Views: 211
Posted By salimshah
Welcome to CL. When you call around for...

Welcome to CL.

When you call around for pricing make sure you ask exactly what would be done. Some places will do only what you ask and some will add on needed items at 90k plus some additional...
Forum: RX - First Generation 03-17-15, 10:00 PM
Replies: 22
Views: 709
Posted By salimshah
Lot of what I am going to state is extremely...

Lot of what I am going to state is extremely subjective, so please give me lot of latitude,
Age:
We all would like to own and drive a vehicle till it quits or till we get bored and want a change....
Forum: RX - First Generation 03-17-15, 11:20 AM
Replies: 15
Views: 320
Posted By salimshah
You decide what is best for you. If you plan to...

You decide what is best for you. If you plan to replace get the seals and locking clip. Seals come out easy specially when you intend to trash them :) You can jury rig a seal driver by oversized...
Forum: RX - First Generation 03-17-15, 07:01 AM
Replies: 15
Views: 320
Posted By salimshah
Yours and mine have almost the same miles and I...

Yours and mine have almost the same miles and I replaced my boot and re-greased the inner 20k miles back and serviced the other 8k miles back. [inners]. If the joint is NOT clicking, the OEM service...
Forum: RX - First Generation 03-16-15, 06:55 PM
Replies: 22
Views: 709
Posted By salimshah
Oh no! You bought a 16 yr old vehicle...

Oh no!

You bought a 16 yr old vehicle labelled Lexus, built by Toyota. Did not share how many miles on the odo. You did not share if you looked at the history before making the purchase.
...
Forum: RX - First Generation 03-16-15, 06:36 PM
Replies: 1
Views: 95
Posted By salimshah
Depends on your skill and tools. It is not a...

Depends on your skill and tools.

It is not a simple remove and install. There is alignment concern (remeasure) or use the factory set position [you mark it before removing .. which may be lost in...
Forum: RX - First Generation 03-16-15, 04:22 PM
Replies: 6
Views: 241
Posted By salimshah
I recommend OE for sensors and plugs. Next...

I recommend OE for sensors and plugs.

Next if the Original gave you plenty of miles and you want to keep the vehicle for a while then it is worth the extra price. Also the OE comes with sure fit...
Showing results 1 to 25 of 500

 
Forum Jump
All times are GMT -7. The time now is 07:22 AM.

Join ClubLexus

Copyright © 2000-2015 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS


Get all contact info