Go Back   Club Lexus Forums > Search Forums
Sign in using an external account
Register Forgot Password?

Showing results 1 to 25 of 490
Search took 0.30 seconds.
Search: Posts Made By: HtownBlue
Forum: RX - Second Generation 12-06-14, 02:54 PM
Replies: 1
Views: 218
Posted By HtownBlue
When you post next time friend, be more specific....

When you post next time friend, be more specific. You failed to mention if you have air suspension or standard.

My guess is you either have an issue with your height sensors which are attached...
Forum: RX - Second Generation 11-29-14, 08:56 PM
Replies: 8
Views: 527
Posted By HtownBlue
You have an issue with your blower fan motor most...

You have an issue with your blower fan motor most likely. Could be debris in there but likely the motor itself.
Forum: RX - Second Generation 11-24-14, 11:41 PM
Replies: 15
Views: 831
Posted By HtownBlue
In fact I did. I was curious as to why the...

In fact I did. I was curious as to why the discrepancy. The rods and cam lobes are apparently different than some of the Toyota V6 engines used in other models. At least that is what I could...
Forum: RX - Second Generation 11-24-14, 06:57 PM
Replies: 15
Views: 831
Posted By HtownBlue
The 3.3 is not an interference engine. It has...

The 3.3 is not an interference engine. It has the compression ratio and lower end of the Toyota interference engines, but the head and valves are modeled after the 3.0 engine which is NOT an...
Forum: RX - Second Generation 11-02-14, 06:00 PM
Replies: 5
Views: 319
Posted By HtownBlue
Without seeing the fuel trim numbers just after...

Without seeing the fuel trim numbers just after cold start, it will be hard to diagnose. It's normal for the engine to have to crank over a slight bit extra after sitting for a while if you...
Forum: RX - Second Generation 10-22-14, 08:58 PM
Replies: 3
Views: 296
Posted By HtownBlue
What Next, Kiwi is unfortunately...

What Next,

Kiwi is unfortunately incorrect. Your car has 3 belts. Two that are exposed on the passenger side of the engine compartment. One works the alternator and AC. The other is your...
Forum: RX - Second Generation 10-04-14, 01:14 PM
Replies: 7
Views: 351
Posted By HtownBlue
You can find one cheaper online. No way should...

You can find one cheaper online. No way should you go to dealer.
Forum: RX - Second Generation 09-21-14, 05:32 PM
Replies: 10
Views: 693
Posted By HtownBlue
I got the multi vehicle scanner. I volunteer my...

I got the multi vehicle scanner. I volunteer my time fixing vehicles for elderly and single parents that cannot afford it so I needed a scanner that could communicate with multiple vehicles.
Forum: RX - Second Generation 09-21-14, 01:51 PM
Replies: 10
Views: 693
Posted By HtownBlue
It passed inspection for the three years I had...

It passed inspection for the three years I had the issue. The ABS only activated when approaching 2-3 mph. And only for a half a second maybe. And the car stopped fine. No issues stopping. No code...
Forum: RX - Second Generation 09-20-14, 11:40 AM
Replies: 10
Views: 693
Posted By HtownBlue
The brand of the scanner is Creader or Cread@r...

The brand of the scanner is Creader or Cread@r VII by Launch. I think that's the brand. That's what the box says.

The rear sensors were reading perfectly normal. I can read the live data on...
Forum: RX - Second Generation 09-15-14, 01:30 PM
Replies: 13
Views: 795
Posted By HtownBlue
You have several rubber tubes that connect I to...

You have several rubber tubes that connect I to the manifold and the air intake as well as the EGR VALVES. I would start the engine and open the hood. See if you hear a whistling noise coming from...
Forum: RX - Second Generation 09-14-14, 06:56 PM
Replies: 13
Views: 795
Posted By HtownBlue
Do you have a 350 or 330? The 330 does not have...

Do you have a 350 or 330? The 330 does not have a tensioner pulley for the serpentine belt that operates the AC and alternator. The tension is adjusted by the bracket adjustment at the alternator on...
Forum: RX - Second Generation 09-12-14, 08:31 PM
Replies: 10
Views: 693
Posted By HtownBlue
VICTORY!!!! Fianlly Solved an ABS problem.

Situation and background:

2.5 YEARS AGO....Yes 2.5 YEARS AGO....in a far far land somewhere in Texas.....

I replaced my front bearings. During this procedure I obviously disconnected the...
Forum: RX - Second Generation 09-07-14, 12:08 AM
Replies: 11
Views: 408
Posted By HtownBlue
Check the cabin temp sensor. It is below the...

Check the cabin temp sensor. It is below the steering wheel just to the right and has a square vent like covering I I recall correctly. It can get dust and build up on it which effects air temp...
Forum: RX - Second Generation 09-06-14, 11:42 AM
Replies: 11
Views: 408
Posted By HtownBlue
Battery is fool's gold. Battery voltage level...

Battery is fool's gold. Battery voltage level will have little to do with A/C performance once car is started as the entire car runs off alternator once started.

Check the following:
Freon...
Forum: RX - Second Generation 08-26-14, 09:44 AM
Replies: 7
Views: 722
Posted By HtownBlue
Alchemist, Glad to hear it all worked out. You...

Alchemist, Glad to hear it all worked out. You should be riding smooth for quite a while.
Forum: RX - Second Generation 08-23-14, 08:21 PM
Replies: 2
Views: 269
Posted By HtownBlue
It's your cv axles if they make noise when...

It's your cv axles if they make noise when turning sharply. They will wobble at high speeds as well. Throw car in neutral at high speed and see if the vibration goes away. If so it's your axles.
Forum: RX - Second Generation 08-03-14, 12:46 PM
Replies: 14
Views: 2,146
Posted By HtownBlue
Bad strut in the air strut assembly. Leak in...

Bad strut in the air strut assembly. Leak in system somewhere. Height sensor. Or fault in settings. 1 of the four. Trust me. I went through my entire system before I did my conversion to...
Forum: RX - Second Generation 07-27-14, 10:07 PM
Replies: 5
Views: 392
Posted By HtownBlue
Yeah those bolts in the back are horrendous. I...

Yeah those bolts in the back are horrendous. I had to use a 12mm ratcheting wrench click by click to get them undone.
Forum: RX - Second Generation 07-27-14, 04:16 PM
Replies: 5
Views: 392
Posted By HtownBlue
You might consider replacing the rear coils and...

You might consider replacing the rear coils and plugs while you've got it all apart. Also I would replace the valve cover gaskets while you can get at them easily. Just a preventative measure which...
Forum: RX - Second Generation 07-19-14, 09:26 PM
Replies: 7
Views: 510
Posted By HtownBlue
You may have too much or too little air getting...

You may have too much or too little air getting into the cylinder. Also a clogged injector or foiled injector would cause this issue. Compression test would be in order as well just to make sure. ...
Forum: RX - Second Generation 07-13-14, 07:31 PM
Replies: 1
Views: 518
Posted By HtownBlue
Pretty standard except for spring compression. ...

Pretty standard except for spring compression. Make sure mount is placed properly in alignment with the straight edge on the strut shaft.
Forum: RX - Second Generation 07-11-14, 05:45 PM
Replies: 9
Views: 594
Posted By HtownBlue
Anything AFTER THE LAST O2 sensor will not effect...

Anything AFTER THE LAST O2 sensor will not effect the computer and how it governs the engine. As for if it would effect anything else, I don't think it would.
Forum: RX - Second Generation 06-29-14, 09:14 PM
Replies: 6
Views: 514
Posted By HtownBlue
Sounds like starter to me.

Sounds like starter to me.
Forum: RX - Second Generation 06-28-14, 06:13 PM
Replies: 30
Views: 2,127
Posted By HtownBlue
Switch to neutral at high speed and see if noise...

Switch to neutral at high speed and see if noise goes away. If so it's tranny or drive shaft related. If not it's wheel bearings or tires.
Showing results 1 to 25 of 490

 
Forum Jump
All times are GMT -7. The time now is 06:15 AM.

Join ClubLexus
Advertising


Copyright © 2000-2008 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS


Get all contact info