Go Back   Club Lexus Forums > Search Forums
Sign in using an external account
Register Forgot Password?

Showing results 1 to 25 of 494
Search took 0.40 seconds.
Search: Posts Made By: salimshah
Forum: RX - First Generation Yesterday, 10:57 AM
Replies: 13
Views: 561
Posted By salimshah
Bit of clarification on "snow mode" Snow...

Bit of clarification on "snow mode"

Snow mode disables low gear, thus limiting torque to the wheel. If your vehicle is not moving and you apply lot of torque to the wheels on ice (snow turned into...
Forum: RX - First Generation Yesterday, 09:06 AM
Replies: 25
Views: 723
Posted By salimshah
Clogs are very unlikely. You may like to...

Clogs are very unlikely.

You may like to check the pressure of the fuel.

The next choke points are the injectors ... just like the pump side, we have a electromechanical device.

You need to...
Forum: RX - First Generation 12-18-14, 02:22 PM
Replies: 2
Views: 88
Posted By salimshah
The side steps are not a standard issue. You will...

The side steps are not a standard issue. You will have to look for an aftermarket solution. Onus is on the manufacturer to guarantee fitment and provide Step by Step DIY.

Salim
Forum: Suspension and Brakes 12-17-14, 11:04 PM
Replies: 17
Views: 693
Posted By salimshah
Answering my question for the benefit of future...

Answering my question for the benefit of future readers ..

Keep the wear indicator towards the bottom (leading edge). Then just pair up the outers.

Salim
Forum: RX - First Generation 12-17-14, 10:59 PM
Replies: 1
Views: 186
Posted By salimshah
Check out the Special interest group here in CL ...

Check out the Special interest group here in CL

PDR (paintless dent repair) usually adds up real quick. 2 dent repairs may vaporize $120.

Salim
Forum: RX - First Generation 12-16-14, 11:08 PM
Replies: 7
Views: 312
Posted By salimshah
69 in-lb Salim

69 in-lb

Salim
Forum: RX - First Generation 12-16-14, 11:00 PM
Replies: 5
Views: 285
Posted By salimshah
You have listed some more information but there...

You have listed some more information but there are some gaps.

Steering without engine running:
Ignition key has a lock position. As you pull the key out it gets armed.You can turn with effort...
Forum: Suspension and Brakes 12-16-14, 08:59 PM
Replies: 17
Views: 693
Posted By salimshah
Leading edge chamfer or scallop?

Picked up OEM front pads. Pads are not marked Left or Right

I can pair the pads (inner-outer) in 2 combinations based on edges. One gives me short chamfer on one edge and the deep scallop on the...
Forum: Suspension and Brakes 12-16-14, 08:41 PM
Replies: 13
Views: 398
Posted By salimshah
Dont forget to check the torque on all suspension...

Dont forget to check the torque on all suspension nut and bolts. I found mine were loose only after getting the vehicle up on the rack.

Salim
Forum: RX - First Generation 12-16-14, 08:45 AM
Replies: 5
Views: 285
Posted By salimshah
Please go through the having problems sticky. ...

Please go through the having problems sticky.

Few things need more explanation ... steering feel before starting the engine or after?
Unable to start?

Salim
Forum: RX - First Generation 12-16-14, 08:40 AM
Replies: 12
Views: 389
Posted By salimshah
I hope the RX protected the occupants and no one...

I hope the RX protected the occupants and no one including the others got hurt. Seems like engine, drive and structural are not impacted.

Let us know what your plans are.

Salim
Forum: RX - First Generation 12-15-14, 12:11 PM
Replies: 47
Views: 7,064
Posted By salimshah
Bob has a good handle on it, but as a 3rd person...

Bob has a good handle on it, but as a 3rd person I would say dont get carried away on getting close match to the readings Bob has.

The fuse with contacts are supposed to be "0 ohm" in theory and...
Forum: RX - First Generation 12-15-14, 11:19 AM
Replies: 7
Views: 312
Posted By salimshah
Before folks go and start replacing the valve...

Before folks go and start replacing the valve cover gasket, they should attempt to retorque the bolts down (to proper spec) evenly (criss cross pattern inside to out). @100k miles.

I am sure there...
Forum: RX - First Generation 12-15-14, 12:42 AM
Replies: 24
Views: 500
Posted By salimshah
Matt: It seems the belt was replaced, so...

Matt:

It seems the belt was replaced, so wait till 200k miles. If any thing leaks then you will have to get in and address it. The belt itself is about $45, so if you open (or have it opened up)...
Forum: RX - First Generation 12-15-14, 12:31 AM
Replies: 3
Views: 133
Posted By salimshah
Matt: The screen sits in the fuel tank and...

Matt:

The screen sits in the fuel tank and gets cleaned by the fuel that gets sloshed in the tank.

Unless you buy gas from bad pumps or constantly run low, the chance of the filter getting...
Forum: RX - First Generation 12-15-14, 12:24 AM
Replies: 47
Views: 7,064
Posted By salimshah
I assume you mean Volt Meter. Which can be a VOM...

I assume you mean Volt Meter. Which can be a VOM set in reading voltage.

Bob's reading are showing mv -> millivolt.

I would have made the measurement by setting the meter in 'current mode' but...
Forum: RX - First Generation 12-14-14, 12:29 PM
Replies: 25
Views: 723
Posted By salimshah
I am totally lost. If with a new pump and...

I am totally lost.

If with a new pump and without using a jump of 12v to the pump, your fuel pump is pumping gasoline but you are not getting gasoline at the union/quick_connector [at the bottom...
Forum: RX - First Generation 12-14-14, 08:23 AM
Replies: 8
Views: 240
Posted By salimshah
First diagnosed here remotely by hyper and with...

First diagnosed here remotely by hyper and with no charge.:D

I would suggest stay here (CL) and post often, specially to help out others.


Salim
Forum: RX - First Generation 12-12-14, 07:37 PM
Replies: 4
Views: 221
Posted By salimshah
Recently or after the incident? Salim

Recently or after the incident?

Salim
Forum: RX - First Generation 12-12-14, 12:16 PM
Replies: 8
Views: 240
Posted By salimshah
Have your exhaust checked out near the flex...

Have your exhaust checked out near the flex coupling and around the bottom of the WU-CAT. [area around the oil filter]

Salim
Forum: RX - First Generation 12-12-14, 11:40 AM
Replies: 24
Views: 500
Posted By salimshah
I can share what I do, but this is not a hard and...

I can share what I do, but this is not a hard and fast rule to follow dealing with timing belt chain ... the acc belt has 45-60k interval change. I only use OEM

1. Timing belt every (90k-110k)
2....
Forum: RX - First Generation 12-12-14, 11:30 AM
Replies: 24
Views: 500
Posted By salimshah
Only from the person who sold you the vehicle ...

Only from the person who sold you the vehicle

Salim
Forum: RX - First Generation 12-12-14, 08:46 AM
Replies: 24
Views: 500
Posted By salimshah
All folks with 'new to me' vehicles should visit...

All folks with 'new to me' vehicles should visit dealership and get a dump on maintenance (done by dealer) records.

Salim
Forum: RX - First Generation 12-11-14, 09:22 PM
Replies: 6
Views: 234
Posted By salimshah
What sort of leak are you talking about? Oil?...

What sort of leak are you talking about? Oil? Valve cover deals with Oil.

Are you loosing coolant mysteriously? You know that combustion produces water and before the exhaust gets warm the water...
Forum: RX - First Generation 12-11-14, 03:03 PM
Replies: 2
Views: 96
Posted By salimshah
Look at it objectively .. if this is not a common...

Look at it objectively .. if this is not a common size, you are stuck with the dealer. Just visit the parts store and let them bring the part (if not stocked). It should be less than $10 (my...
Showing results 1 to 25 of 494

 
Forum Jump
All times are GMT -7. The time now is 08:34 AM.

Join ClubLexus
Advertising


Copyright © 2000-2008 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS


Get all contact info