Go Back   Club Lexus Forums > Search Forums
Sign in using an external account
Register Forgot Password?

Showing results 1 to 25 of 385
Search took 0.22 seconds.
Search: Posts Made By: Dream36
Forum: SC 400/300 09-04-14, 01:35 PM
Replies: 14
Views: 565
Posted By Dream36
I drink redbull 8.4oz and I'm sick of it sliding...

I drink redbull 8.4oz and I'm sick of it sliding around in the big azzz hole. Is there a smaller solution???

When I made my shifter surround in the rx7 I made a redbull sized cup holder and a...
Forum: SC400 / 300 Classifieds 09-01-14, 05:13 PM
Replies: 27
Views: 1,436
Posted By Dream36
Sc400 maf for cheap?

Sc400 maf for cheap?
Forum: SC 400/300 09-01-14, 01:19 AM
Replies: 52
Views: 2,607
Posted By Dream36
Motor doesn't work on my driver seat so I've been...

Motor doesn't work on my driver seat so I've been through the process a few times. There is a bolt/nut looking thing under the seat. It is against the trans tunnel (for reference) you will have to...
Forum: SC 400/300 08-31-14, 03:38 AM
Replies: 15
Views: 679
Posted By Dream36
It's not as bad as you may think. Went through...

It's not as bad as you may think. Went through the process wih my 78 SA22c. The key is to make sure it is imported legally first. If you don't go through the proper channels they will take it. After...
Forum: NELOC 08-07-14, 12:53 PM
Replies: 2,633
Sticky: Spotted
Views: 501,415
Posted By Dream36
Agreed, I see modded ESs all day and the...

Agreed, I see modded ESs all day and the occasional IS. There is a few clean LSs in Wilmington but I'm in Newark now. Last night I went light to light with a SC430. He laughed because I was keeping...
Forum: SC 400/300 08-05-14, 06:13 PM
Replies: 1
Views: 143
Posted By Dream36
It's the acv. On my sc400 it was part if the high...

It's the acv. On my sc400 it was part if the high pressure hose not the pump. It has two vac lines to it. When u find it all u need to do is take the piece to an auto part store and test fit oil...
Forum: SC400 / 300 Classifieds 08-03-14, 10:52 AM
Replies: 2,708
Views: 466,564
Posted By Dream36
How about passenger side front nuckle/hub...

How about passenger side front nuckle/hub assembly in working order?

I paid a ton of money for a shop to repair bearing only to screw it up and ruin the nuckle piece :(
Forum: SC 400/300 08-01-14, 01:23 PM
Replies: 6
Views: 514
Posted By Dream36
Done this with several cars. You can just do like...

Done this with several cars. You can just do like the pic, disassemble factor rails. Bolt rails to car (without seat), weld them to a flat bar stock. Remove rails, align rails to new seat and weld...
Forum: Performance & Maintenance 08-01-14, 01:20 PM
Replies: 5
Views: 207
Posted By Dream36
I was under the impression that zero ohms equals...

I was under the impression that zero ohms equals happy sensor. Ie. unplug it and the car will think its full. Mine is currently cracked all around the sensor so I took a plastic bag (the kind I work...
Forum: Performance & Maintenance 07-14-14, 04:00 PM
Replies: 29
Views: 1,631
Posted By Dream36
Looking good. I've got a bazillion photos similar...

Looking good. I've got a bazillion photos similar when shoving the same combo in my last car. You may want to check out speedhut for your gauges (I got the revolution style for the rx7). Other than...
Forum: Performance & Maintenance 07-14-14, 10:35 AM
Replies: 2
Views: 158
Posted By Dream36
Still need to know please. It's payday when I get...

Still need to know please. It's payday when I get off work 2am. If there was a local shop that sold couplings it'd be a nonissue but I gotta order online :/
Forum: SC 400/300 07-13-14, 01:13 PM
Replies: 16
Views: 895
Posted By Dream36
Must use all oem parts here. Upgraded wheels or...

Must use all oem parts here. Upgraded wheels or tinted windows will disqualify you from tags and the police will ticket you if you change it after inspection. Other than that yep exept from...
Forum: Performance & Maintenance 07-13-14, 01:09 PM
Replies: 2
Views: 167
Posted By Dream36
How's ur tranny > dif alignment? If off by a...

How's ur tranny > dif alignment? If off by a degree it could cause these symptoms.
Forum: Performance & Maintenance 07-12-14, 05:51 PM
Replies: 2
Views: 158
Posted By Dream36
Sc400 intake measurements please

Hello all, I'm not really a thread starter so I'll make it brief.
Last winter I pulled my intake piping off to get to the power steering pump. When I pulled it out the accordion hose crumbled in my...
Forum: SC400 / 300 Classifieds 07-11-14, 06:08 PM
Replies: 32
Views: 1,872
Posted By Dream36
Where in pa? I'm in delaware. Just discovered a...

Where in pa? I'm in delaware. Just discovered a crack in coolant res so I'm looking to pick up
Forum: SC400 / 300 Classifieds 07-05-14, 12:53 PM
Replies: 5
Views: 448
Posted By Dream36
I need the factory exhaust manifolds but I'm...

I need the factory exhaust manifolds but I'm looking to borrow a set for mock up :( good prices tho and good luck
Forum: Performance & Maintenance 07-04-14, 12:28 PM
Replies: 1
Views: 197
Posted By Dream36
It's good as in if the fuel ECU is faulty. Other...

It's good as in if the fuel ECU is faulty. Other than that (and if fuel pump getting weak) it is pointless.

People say it is bad on the system, it does shorten the life if the pump by 5%...
Forum: Performance & Maintenance 06-23-14, 11:45 AM
Replies: 30
Views: 20,884
Posted By Dream36
About $200 - $800 in materials (mufflers can be a...

About $200 - $800 in materials (mufflers can be a slow as $40 each but can go up to $200). And if you supply everything about three hours labor in the lift (most shops charge around $100 an hour). I...
Forum: Performance & Maintenance 06-19-14, 12:03 PM
Replies: 26
Views: 1,777
Posted By Dream36
I've had to follow every step on the how to on...

I've had to follow every step on the how to on fixing hesitations. I've replaced coils every few months, fuel ECU mod, cats delete, new caps and rotors, new wires, fuel filter and only when I got a...
Forum: SC 400/300 06-19-14, 09:13 AM
Replies: 2
Views: 298
Posted By Dream36
I used a 4" PVC pipe and two end caps to make one...

I used a 4" PVC pipe and two end caps to make one for my rx7 as it never came with one (1978 display car) to pass inspection. I just filled it with active carbon. Worked well enough to pass...
Forum: SC 400/300 06-17-14, 01:53 PM
Replies: 40
Views: 1,903
Posted By Dream36
I like it. Only looks good on wide bodies tho. I...

I like it. Only looks good on wide bodies tho. I almost put them on my rx7 (if I didn't total it I woulda by now). Don't let haters get under your skin, trust me the members here aren't getting bad,...
Forum: SC 400/300 06-13-14, 05:36 AM
Replies: 4,751
Views: 342,697
Posted By Dream36
Got a trade offer for 03 legacy wagon 5spwed. So...

Got a trade offer for 03 legacy wagon 5spwed. So cleaning interior fixing duct tape and sealing last headlight so he can see it tomorrow.
Forum: SC 400/300 06-10-14, 10:45 AM
Replies: 4,751
Views: 342,697
Posted By Dream36
At 8am I took her to the car wash and prepped her...

At 8am I took her to the car wash and prepped her for a perspective buyer at noon. The guy calls said he was 5 minutes out. So I to to meet him and what do I find? The apartment mowers once again...
Forum: SC 400/300 06-08-14, 01:19 PM
Replies: 40
Views: 2,017
Posted By Dream36
Yep, it won't go that high even with everything...

Yep, it won't go that high even with everything included. I've had my SC on the market for almost six months. With the exception of random questions I've had zero bites. I have my asking price too...
Forum: SC 400/300 06-06-14, 01:54 PM
Replies: 4,751
Views: 342,697
Posted By Dream36
I've had good success with the same brand black...

I've had good success with the same brand black wax, however in. Order for it to look good you need to go over it with a second clear wax to make it "pop"
Showing results 1 to 25 of 385

 
Forum Jump
All times are GMT -7. The time now is 05:19 PM.

Join ClubLexus
Advertising


Copyright © 2000-2008 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS


Get all contact info