Club Lexus Forums - Search Results


Go Back   Club Lexus Forums > Search Forums
Log In 

Showing results 1 to 21 of 21
Search took 0.21 seconds.
Search: Posts Made By: dganapol
Forum: RX - 2nd Gen (2004-2009) 01-29-16, 07:04 AM
Replies: 55
Views: 27,205
Posted By dganapol
It allows you to use the Nav over 5 mph. ...

It allows you to use the Nav over 5 mph.

David
Forum: RX - 2nd Gen (2004-2009) 01-28-16, 06:03 AM
Replies: 4
Views: 314
Posted By dganapol
Test the battery when turning the key. It will...

Test the battery when turning the key. It will probably go to nothing. Also, turn on lights and test the battery it will probably go to 10v. Sounds like battery.

David
Forum: RX - 2nd Gen (2004-2009) 01-26-16, 07:48 AM
Replies: 4
Views: 308
Posted By dganapol
Does it come out? Also, why not just reline it...

Does it come out? Also, why not just reline it with new material.

David
Forum: RX - 2nd Gen (2004-2009) 01-04-16, 04:32 AM
Replies: 3
Views: 318
Posted By dganapol
The compression is normal it is the bend in the...

The compression is normal it is the bend in the spring. This is the reason I cannot compress. I even used the manual type and could not compress enough. I looked at the pictures of the DIY post...
Forum: RX - 2nd Gen (2004-2009) 12-31-15, 07:10 PM
Replies: 5
Views: 268
Posted By dganapol
Thanks, I looked at Lexus and they are $153.00. ...

Thanks, I looked at Lexus and they are $153.00. I will try them out.

Daivd
Forum: RX - 2nd Gen (2004-2009) 12-31-15, 04:25 PM
Replies: 5
Views: 268
Posted By dganapol
Thanks for the information. Anyway you can...

Thanks for the information. Anyway you can provide the link in Amazon or manufacture of the bulb?

Thx,
David
Forum: RX - 2nd Gen (2004-2009) 12-31-15, 04:20 PM
Replies: 3
Views: 318
Posted By dganapol
Update #1 I found the spec on the height and...

Update #1

I found the spec on the height and it is 392.6mm which is 15 and 29/64in , I measured the spring and they are at 15in, new ones on their way.

David
Forum: RX - 2nd Gen (2004-2009) 12-31-15, 09:01 AM
Replies: 6
Views: 508
Posted By dganapol
Hi Lazyj321, For me at 150k miles...

Hi Lazyj321,

For me at 150k miles the ball joint made more difference in driving feel more then the control arms. You are correct the ball joint was difficult to get off due to I rounded...
Forum: RX - 2nd Gen (2004-2009) 12-30-15, 05:31 PM
Replies: 3
Views: 318
Posted By dganapol
Strut coil spring bad?

All,

I have been having a hard time getting the spring to compress correctly. They have to be in the center for the mount to go on. I have tried the floor model as you can see from the...
Forum: RX - 2nd Gen (2004-2009) 12-30-15, 10:09 AM
Replies: 6
Views: 1,909
Posted By dganapol
HI, I am doing this job now. I actually...

HI,

I am doing this job now. I actually have the floor model strut spring compressor, but it will not work on my springs. It looks like my springs are miss formed, They are asymmetrical and...
Forum: RX - 2nd Gen (2004-2009) 12-30-15, 09:49 AM
Replies: 2
Views: 184
Posted By dganapol
Hi, I had the bead problem, I had to get...

Hi,

I had the bead problem, I had to get is resurfaced at tire rim shop, corrosion.

David
Forum: RX - 2nd Gen (2004-2009) 12-30-15, 09:45 AM
Replies: 6
Views: 508
Posted By dganapol
Hi, I just did this job and it is a...

Hi,

I just did this job and it is a "bear" it is about a 7 or 8 job. Things to be careful:

1. When jacking up the engine on the transmission make sure you use a very flat block of wood and...
Forum: RX - 2nd Gen (2004-2009) 08-10-15, 05:53 AM
Replies: 3
Views: 1,245
Posted By dganapol
I agree!! Unfortunately, the Costco's around me...

I agree!! Unfortunately, the Costco's around me do not do TPMS sensors. The dealer and tire service places were just too expensive. And I was tired of getting the runaround of just push the...
Forum: RX - 2nd Gen (2004-2009) 08-09-15, 11:43 AM
Replies: 3
Views: 1,245
Posted By dganapol
TPMS Finally figured it out!!

All,

My TPMS light went on at the beginning of the year and I reset it and it would reset most of time and that seemed to work. After 7-8 years I figured it was the sensors themselves. I...
Forum: RX - 2nd Gen (2004-2009) 08-08-15, 11:56 PM
Replies: 4
Views: 615
Posted By dganapol
Do a search and you will find it is the brake...

Do a search and you will find it is the brake light switch on the petal.

David
Forum: RX - 2nd Gen (2004-2009) 11-29-14, 12:17 PM
Replies: 22
Views: 2,038
Posted By dganapol
Lift gate shock/strut repair

All,

I just replaced my lift gate strut. The original struts are captured in the brackets and I had to order new brackets 2007 RX350.

Use the following numbers: Ordered from Sewell
...
Forum: RX - 2nd Gen (2004-2009) 07-06-14, 11:09 AM
Replies: 2
Views: 873
Posted By dganapol
This is not for the "faint" of heart

Well I got the bolt out, took 10hrs. As you can see from the pictures there are brackets all over the coils. More has to come off. I have enough pictures and I will writeup a 2007 USA made if...
Forum: RX - 2nd Gen (2004-2009) 07-06-14, 08:05 AM
Replies: 2
Views: 873
Posted By dganapol
Major problem getting intake manifold off

The bolt on the back of the manifold on the passenger side, I cannot get to. I was able to back the bolt off almost all of the way, but the head is now under a wire loom. I cannot even see it...
Forum: RX - 2nd Gen (2004-2009) 07-05-14, 09:37 PM
Replies: 3
Views: 1,167
Posted By dganapol
What a waste of time.

I am replacing the spark plugs on a 2007 RX350 made in the USA. I have spent the greater part of a day over 9hrs trying to get the passenger side bolt out of the air box. I have attached a picture...
Forum: SC- 1st Gen (1992-2000) 09-28-03, 06:57 PM
Replies: 4
Views: 1,047
Posted By dganapol
I had the 42.5 mph hesitation (stilled not...

I had the 42.5 mph hesitation (stilled not cured). During my timing belt change I adjusted the TPS. I did not adjust it right the first time and when I started the engine it did not want to run....
Forum: Performance & Maintenance 08-24-02, 01:07 PM
Replies: 6
Views: 931
Posted By dganapol
Timing belt change

I just did this job. You will need the following:
1. Timing belt
2. Bearing #1
3. Bearing #2
4. Water pump (change as long as your in there)
5. Serpentine belt bearing
6. Serpentine tensioner...
Showing results 1 to 21 of 21

 
Forum Jump

All times are GMT -7. The time now is 05:32 PM.



Copyright © 2000-2015 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS