Club Lexus Forums - Search Results


Go Back   Club Lexus Forums > Search Forums
Log In 

Showing results 1 to 25 of 496
Search took 0.41 seconds.
Search: Posts Made By: burny
Forum: GS - 3rd Gen (2006-2011) 02-06-16, 06:43 AM
Replies: 10
Views: 325
Posted By burny
Philips off Amazon

Philips off Amazon
Forum: GS - 3rd Gen (2006-2011) 02-04-16, 06:08 AM
Replies: 116
Views: 21,260
Posted By burny
They only replace the gasket, not the sensor...

They only replace the gasket, not the sensor itself. It is not that involved. Sensor is in area of engine closest to firewall about center of windshield. they have done enough of these that an...
Forum: Maintenance 02-02-16, 01:26 PM
Replies: 5
Views: 6,658
Posted By burny
go into the 3rd generation gs350 forum. There is...

go into the 3rd generation gs350 forum. There is a DIY in there. It is a little tedious but not that big of deal. I did my wife's back at 80k and it now has 115k on it. I ran 13 quarts through then...
Forum: GS - 3rd Gen (2006-2011) 01-30-16, 02:28 PM
Replies: 16
Views: 701
Posted By burny
under the back seat on Drivers side I believe

under the back seat on Drivers side I believe
Forum: GS - 2nd Gen (1998-2005) 01-30-16, 05:58 AM
Replies: 9
Views: 272
Posted By burny
^what they said, seized caliper. take it off and...

^what they said, seized caliper. take it off and grease the slide pins and see if that helps
Forum: GS - 3rd Gen (2006-2011) 01-29-16, 11:44 AM
Replies: 90
Views: 32,602
Posted By burny
Do it Rosie

Do it Rosie
Forum: GS - 3rd Gen (2006-2011) 01-28-16, 11:20 AM
Replies: 5
Views: 5,942
Posted By burny
i did the 07 in an hour. Did not remove...

i did the 07 in an hour. Did not remove compressor. Just wiggled it through upper radiator hose area
Forum: GS - 3rd Gen (2006-2011) 01-27-16, 12:20 PM
Replies: 13
Views: 1,262
Posted By burny
Yes, the curtain has to be pulled back to access...

Yes, the curtain has to be pulled back to access the 3 nuts on each rear strut. I used a clip tool and had it out in 3 minutes.
Forum: Maintenance 01-27-16, 08:53 AM
Replies: 4
Views: 252
Posted By burny
BuggerOkie, did it work?

BuggerOkie, did it work?
Forum: GS - 3rd Gen (2006-2011) 01-27-16, 08:47 AM
Replies: 13
Views: 1,262
Posted By burny
I have to guess as I always do my own. I would...

I have to guess as I always do my own. I would say no more than $150 per wheel for labor. $100 would be more palatable considering it is not that difficult.
Forum: GX - 1st Gen (2004-2009) 01-27-16, 05:42 AM
Replies: 2
Views: 225
Posted By burny
Can you tell me which motor you used for the...

Can you tell me which motor you used for the repair? Did it have a round shaft or a D shaft with one side flat?
Forum: GS - 3rd Gen (2006-2011) 01-27-16, 05:37 AM
Replies: 13
Views: 1,262
Posted By burny
any independent shop with a good reputation can...

any independent shop with a good reputation can handle the job.
Forum: GS - 3rd Gen (2006-2011) 01-26-16, 11:08 AM
Replies: 10
Views: 490
Posted By burny
When my wife's panel came off from driving in...

When my wife's panel came off from driving in high water, i used oversized stainless steel washers from Lowe's to remount it. If you want a new one, try Rockauto
Forum: GS - 3rd Gen (2006-2011) 01-26-16, 11:04 AM
Replies: 25
Views: 3,535
Posted By burny
I had rear driver side actually seize and...

I had rear driver side actually seize and replaced with an A1Cardone off Rockauto. This was 3 years ago and it is fine. Took car in for recall on fuel pressure gasket last year and they called and...
Forum: GX - 1st Gen (2004-2009) 01-26-16, 05:49 AM
Replies: 2
Views: 298
Posted By burny
Nice report. How many miles you have on it? ...

Nice report. How many miles you have on it? when did you switch over from 5-30 to 0-30?
Forum: GS - 3rd Gen (2006-2011) 01-26-16, 05:44 AM
Replies: 19
Views: 611
Posted By burny
What Al said. We are confused.

What Al said. We are confused.
Forum: GS - 2nd Gen (1998-2005) 01-24-16, 03:03 PM
Replies: 18
Views: 724
Posted By burny
I just ordered strong arm as well off Amazon.

I just ordered strong arm as well off Amazon.
Forum: GX - 1st Gen (2004-2009) 01-22-16, 09:12 AM
Replies: 5
Views: 338
Posted By burny
check mylparts.com too. CL5 for discount

check mylparts.com too. CL5 for discount
Forum: GS - 3rd Gen (2006-2011) 01-22-16, 09:11 AM
Replies: 19
Views: 611
Posted By burny
What Al said

What Al said
Forum: GX - 1st Gen (2004-2009) 01-22-16, 06:02 AM
Replies: 13
Views: 684
Posted By burny
Amazon or rockauto. Denso seems to be the one....

Amazon or rockauto. Denso seems to be the one. some use Toyo and Spectra. They are not expensive and an independent shop should do it for a couple hiundred I would think if you furnish the radiator..
Forum: GX - 1st Gen (2004-2009) 01-22-16, 05:58 AM
Replies: 6
Views: 380
Posted By burny
Boo Yah is spot on

Boo Yah is spot on
Forum: GS - 3rd Gen (2006-2011) 01-22-16, 05:54 AM
Replies: 5
Views: 247
Posted By burny
Is there a code? If the igniter or any of the...

Is there a code? If the igniter or any of the coil paks or wires have failed there is a safety feature where the fuel flow is cut off. That would basically start your car for 2-3 seconds before it...
Forum: GX - 1st Gen (2004-2009) 01-19-16, 11:43 AM
Replies: 16
Views: 700
Posted By burny
check out mylparts.com with club lexus discount...

check out mylparts.com with club lexus discount CL5. They will cut key if you scan and send registration.
Forum: GX - 1st Gen (2004-2009) 01-17-16, 02:29 PM
Replies: 10
Views: 1,360
Posted By burny
What he said

What he said
Forum: GX - 1st Gen (2004-2009) 01-10-16, 06:17 PM
Replies: 13
Views: 350
Posted By burny
look at 3 minute mark on this video. The brush...

look at 3 minute mark on this video. The brush ring is usually all you have to replace. Part # 27370-58460

How to rebuild a denso alternator | denso rebuild kit - YouTube

Look at 1:10 mark on...
Showing results 1 to 25 of 496

 
Forum Jump

All times are GMT -7. The time now is 01:52 AM.



Copyright © 2000-2015 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS