jamnall

I have an 02 SC430 with 110k/miles and I also have the vsc light on and abs light. I followed the reset of the light and it worked like a charm, driving the car with no vsc light on until I touch the brakes and then the abs and vsc lights come on again!

Does anyone have a solution for that problem? Also I have a bad wheel bearing on the front drivers side that I am going to replace tomorrow, I will try the reset after replacing the bearing and see if cures it!

jamnall

Well I put the wheel bearing on and reset the vsc light, but once again the lights come back on after a mile of driving. Any other suggestions?

talwang

iTrader: (4)

VSC + VSC OFF + ABS lights almost guarantee a failed wheel sensor on the sc430.
It is usually in the front.
You need to get a trouble code using a hand held device to determine which one goes bad.
I just replaced one not long ago.

thelopez

Mine was the wheel sensor. Parts and labor were $250 install. I wonder if there is a Toyota part equivalent.