AZ 1JZ driveshaft, downpipe, intercooler, door panels and more!
#1
1JZ driveshaft, downpipe, intercooler, door panels and more!
I sold my SC300 and I have some leftover parts that I need to get rid of. Prices are OBO
Tan Door Panels - $200 + shipping ($50-70 depending on UPS or Greyhound)
The driver side is in decent shape but the passenger side is starting to detach a little and there's some cracks as pictured below. Also, I will include the driver side switch but I don't have the passenger side one nor the light.
Tan Center Console Bezel - $80 + free shipping
The bezel is in good shape but there was a hole drilled above the cup holder for a bluetooth mic
1JZ Driftmotion Downpipe Kit - $100 + free shipping
Brand new kit, never used or installed. Will throw in the v-clamps for an extra $20
1JZ Timing and Serpentine Belts $40 + free shipping
Brand new Bando belts that were again never used. $40 for the pair or $25 for the timing and $20 for the serpentine belt.
Supra MKIII R154 Driveshaft $100 + $50 shipping.
A used manual driveshaft that you can use on your R154 - 1JZ swaps. Heavier item which requires more postage.
Tan Door Panels - $200 + shipping ($50-70 depending on UPS or Greyhound)
The driver side is in decent shape but the passenger side is starting to detach a little and there's some cracks as pictured below. Also, I will include the driver side switch but I don't have the passenger side one nor the light.
Tan Center Console Bezel - $80 + free shipping
The bezel is in good shape but there was a hole drilled above the cup holder for a bluetooth mic
1JZ Driftmotion Downpipe Kit - $100 + free shipping
Brand new kit, never used or installed. Will throw in the v-clamps for an extra $20
1JZ Timing and Serpentine Belts $40 + free shipping
Brand new Bando belts that were again never used. $40 for the pair or $25 for the timing and $20 for the serpentine belt.
Supra MKIII R154 Driveshaft $100 + $50 shipping.
A used manual driveshaft that you can use on your R154 - 1JZ swaps. Heavier item which requires more postage.
#3
Driver School Candidate
Does that drive shaft have an auto carrier yoke on it? If so give me a quote to 32137. Or if you would consider selling the front half with the trans yoke that would be awesome!
#5
Driver School Candidate
Thinking I could also use just the front part. Gotta measure and see...
#6
Driver School Candidate
Found the answer to my question! I just need the front section and trans yoke. The rear section will work off my driveshaft. Any way you would be willing to separate them to save me on shipping? I'll still pay the 100
Trending Topics
#8
Driver School Candidate
Thread
Thread Starter
Forum
Replies
Last Post
myke441990
SC400 / 300 Classifieds
1
10-17-11 10:30 PM