AZ FS: FMIC with piping and Greddy RS BOV
08-31-15, 11:52 AM
#1
FS: FMIC with piping and Greddy RS BOV
This was on my SC that i parted a while back. Kept them to install on my other project but going to a different setup.
These will fit SC with 2jGTE, should also fit 1J setup. Comes with 31×12x4 intercooler, driver side intake plumbing and Greddy RS bov. The part on the BOV was painted black to match my engine bay, it used to be anodized blue. Comes with gasket and extra flange. 45degree Silicone coupler on the piping is black except for the straight coupler which is blue, i just wrapped it with electrical tape so again it will match with my black engine bay. Everything has 2k miles, then i parted out. What you see is what you will get.
$230 shipped, text 480 206 zerosixfivenine.
These will fit SC with 2jGTE, should also fit 1J setup. Comes with 31×12x4 intercooler, driver side intake plumbing and Greddy RS bov. The part on the BOV was painted black to match my engine bay, it used to be anodized blue. Comes with gasket and extra flange. 45degree Silicone coupler on the piping is black except for the straight coupler which is blue, i just wrapped it with electrical tape so again it will match with my black engine bay. Everything has 2k miles, then i parted out. What you see is what you will get.
$230 shipped, text 480 206 zerosixfivenine.
Thread
Thread Starter
Forum
Replies
Last Post
JesLet
SC400 / 300 Classifieds
7
02-03-16 11:48 AM