TX FS PPE Headers & Magnaflow Hi flow cats with factory style flanges.
#1
FS PPE Headers & Magnaflow Hi flow cats with factory style flanges.
Im selling my PPE Headers. They make great power. Ive had them for like 5yrs now. The driver side header has s couple of slight dents in the tube, but that will not have any affect on their performance or their fit. I also have the Magnaflow hi flow cats that bolt right up & still use the factory cat gaskets. These will fit the 98-00 SC400 & 98-00 GS400. $550.00 shipped...
#2
Racer
iTrader: (7)
I could always research but am on my phone at work, why wouldn't they fit on a 97 sc400? Their site shows 92+ compatibility.. Were these used with other mods to make that low 14 second pass in your sig? What all else do you have done to get that time?
I'm a serious buyer, just wondering how much of a difference they really make for the hassle's...
I'm a serious buyer, just wondering how much of a difference they really make for the hassle's...
Last edited by Kris9884; 08-26-14 at 08:33 AM.
#3
They will fit just fine on 92-97 SC400. You just have to do a EGR delete kit. Cause they don't have the EGR port on the passenger side manifold. Other than that. They will work for you... I had a SRT cold air kit with chip & 3:76 gears LSD & block was a 430...
#4
Have these on my car with along with a proper exhaust. They're great and really allow your engine to breathe when combined with an intake or BFI. Stock dyno on 98+ SC's is about 220-230 whp, whereas I am at 270.
This is a great deal as I dont think you can get them anymore
This is a great deal as I dont think you can get them anymore
#5
^^^^^^ Thanks man. Yes they do work great. Yes they are still available from PPE, But they are $600 new. Then you would have another $60 for the 4 flanges from PPE, & then another $200 for the cats. Then whatever your local exhaust shop would charge you to fit them up on the vehicle... Im guessing another $100. So total... You would spend $960... Or $550 shipped, ready to bolt up!
Thread
Thread Starter
Forum
Replies
Last Post
spdrcr771
2Gen GS430 / 400/ 300 Classifieds (98-05)
8
09-05-14 10:49 PM