FL 1jz and 2jz parts for sale!
#1
1jz and 2jz parts for sale!
i have the following items for sale and are located in florida 34983. i really dont wanna ship the big stuff. local pick up is perferred. i am open to trades. but there isn't much i need.
6 Denso 880cc Injectors side feed
$550 obo. you will need a 2jz resistor.
2jzgte USDM injector resistor
$90 obo
1jz block. $200 or best offer.
has pistons and crank. it suffered crank walk. not sure how bad the mains and rod bearings look. but im sure it can be saved.
[
another 1jz block. $300 needs rings.
has new oil pump on it.
no pic of this one. maybe boring it out .20 will make it strong. no spun bearings.
6 Denso 880cc Injectors side feed
$550 obo. you will need a 2jz resistor.
2jzgte USDM injector resistor
$90 obo
1jz block. $200 or best offer.
has pistons and crank. it suffered crank walk. not sure how bad the mains and rod bearings look. but im sure it can be saved.
[
another 1jz block. $300 needs rings.
has new oil pump on it.
no pic of this one. maybe boring it out .20 will make it strong. no spun bearings.
Last edited by DoomLight; 02-25-14 at 06:42 AM.
#2
2jz Aristo Twin Turbos.
$120
got these off my engine swap i purchased. i took them off right away. both are in very good condition. these are NOT usdm turbos. these are JDM. these have ceramic turbines. Y pipe can be included if the buyer wants it.
1jzgte NON vvti manifold
$470 shipped.
CXracing brand. i cut off the 4 bolt waste gate flange and had a 44/46mm V-Band flange welded on. This was only used for a 30 miles before my motor crank walked to its death.
ACT Heavy Duty Extreme Pressure Plate and 6 puck Clutch Disc for R154 with 2400 miles on it.
$300. im not charging for the Disc. just including it.
$120
got these off my engine swap i purchased. i took them off right away. both are in very good condition. these are NOT usdm turbos. these are JDM. these have ceramic turbines. Y pipe can be included if the buyer wants it.
1jzgte NON vvti manifold
$470 shipped.
CXracing brand. i cut off the 4 bolt waste gate flange and had a 44/46mm V-Band flange welded on. This was only used for a 30 miles before my motor crank walked to its death.
ACT Heavy Duty Extreme Pressure Plate and 6 puck Clutch Disc for R154 with 2400 miles on it.
$300. im not charging for the Disc. just including it.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
pilotracer
SC400 / 300 Classifieds
4
02-22-16 03:04 PM
jzs14
SC400 / 300 Classifieds
7
06-01-13 09:34 AM