CA Parts for sale
02-04-14, 09:23 PM
#1
Fuel Injectors, Fujin Lip, MAF Sensor, Lamp Failure Module, etc...
MORE PARTS ADDED AT THE BOTTOM!!!
Call or text: (858)436-6896
Email: damoneydada@yahoo.com
Location: San Diego 92129
Daniel
92-94 SC300 Fuel Injectors - $100
I bought these off of chargerfan a couple weeks back thinking it's the same for my 96 SC300 without doing any research, and my bad it's not the same for my year. This would be a great thing to do as well if you're doing maintenance ignition parts since everything is right there already. It has been fully refurbished, cleaned and tested with new gaskets by Mr. Injector. Check the pic for the results of the tests. Part number is 23250-46030.
95-96 Lamp Failure - $60
Selling this if anyone is interested. I might as well get the one for the 97+ to eliminate the annoying warning light in the cluster. This is $300+ brand new. This works great cause it was lit up the entire time I had the 95-96 custom clear tail light, since I had to use LED bulbs for the brake light since it's been cleared out.
SC400 MAF Sensor - $50
Nothing's wrong with it, I just have extra because I thought it would solve my SC400's bad gas mileage issues, it turns out that it wasn't the problem. I don't need it anymore since I am selling my SC400. Part number is 22204-42011.
MAF Sensor Housing - $10
You can buy this separate without the MAF sensor, or I can include it when you buy the MAF. Just don't want it to go to waste.
92-94 Cornering Lights - $50
Steering Rack Boots for Inner Tie Rods - $15
Perfect replacement for worn out or torn boots, before dirt and dust start taking effect on your inner tie rod seals and start leaking power steering fluid and you'll end up needing a replacement for your steering rack or worst your power steering pump.
SC400 Crank Shaft Oil Seal 90311-A0001 - $10
Timken Rear Wheel Bearings with Inner and Outer Dust Seal 511007 - $130
This is still brand new and never used. I thought my wheel bearing alone went bad, but when we got it off and about to replace it, we realized that the entire hub got damaged, so we ended up replacing the entire hub with one we bought from the junkyard and ended up not using this. My friend threw who worked with me on the car threw away the box before we realized what was wrong with the hub. Brand new from Autozone cost $165 plus another $20 for the seals.
OEM Brake Master Cylinder - $80
I replaced mine with a refurbished one from Autozone some time ago for $175. You can buy this one for $80 and buy the rebuild kit seals for $20 from the dealership.
SC400 Complete Front Brake Calipers and Brackets Set - $50
This one will need a bit of work. I would say do the seals and boots, there's no brake lines included, and no brake pads neither. This is bigger than the OEM SC300 brake calipers, and will stop a lot faster too. Almost the same performance as the LS400 brake calipers if not better. Was only taken out to swap to LS400 brake calipers.
Call or text: (858)436-6896
Email: damoneydada@yahoo.com
Location: San Diego 92129
Daniel
92-94 SC300 Fuel Injectors - $100
I bought these off of chargerfan a couple weeks back thinking it's the same for my 96 SC300 without doing any research, and my bad it's not the same for my year. This would be a great thing to do as well if you're doing maintenance ignition parts since everything is right there already. It has been fully refurbished, cleaned and tested with new gaskets by Mr. Injector. Check the pic for the results of the tests. Part number is 23250-46030.
95-96 Lamp Failure - $60
Selling this if anyone is interested. I might as well get the one for the 97+ to eliminate the annoying warning light in the cluster. This is $300+ brand new. This works great cause it was lit up the entire time I had the 95-96 custom clear tail light, since I had to use LED bulbs for the brake light since it's been cleared out.
SC400 MAF Sensor - $50
Nothing's wrong with it, I just have extra because I thought it would solve my SC400's bad gas mileage issues, it turns out that it wasn't the problem. I don't need it anymore since I am selling my SC400. Part number is 22204-42011.
MAF Sensor Housing - $10
You can buy this separate without the MAF sensor, or I can include it when you buy the MAF. Just don't want it to go to waste.
92-94 Cornering Lights - $50
Steering Rack Boots for Inner Tie Rods - $15
Perfect replacement for worn out or torn boots, before dirt and dust start taking effect on your inner tie rod seals and start leaking power steering fluid and you'll end up needing a replacement for your steering rack or worst your power steering pump.
SC400 Crank Shaft Oil Seal 90311-A0001 - $10
Timken Rear Wheel Bearings with Inner and Outer Dust Seal 511007 - $130
This is still brand new and never used. I thought my wheel bearing alone went bad, but when we got it off and about to replace it, we realized that the entire hub got damaged, so we ended up replacing the entire hub with one we bought from the junkyard and ended up not using this. My friend threw who worked with me on the car threw away the box before we realized what was wrong with the hub. Brand new from Autozone cost $165 plus another $20 for the seals.
OEM Brake Master Cylinder - $80
I replaced mine with a refurbished one from Autozone some time ago for $175. You can buy this one for $80 and buy the rebuild kit seals for $20 from the dealership.
SC400 Complete Front Brake Calipers and Brackets Set - $50
This one will need a bit of work. I would say do the seals and boots, there's no brake lines included, and no brake pads neither. This is bigger than the OEM SC300 brake calipers, and will stop a lot faster too. Almost the same performance as the LS400 brake calipers if not better. Was only taken out to swap to LS400 brake calipers.
Last edited by OG Dada; 10-08-14 at 07:58 PM.
02-10-14, 09:42 AM
#2
Banned
Join Date: Apr 2013
Location: CA
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Rideskinz Fujin Lip - $300
Brand new, never mounted and never painted. I don't know if people know about this, but according to Rideskinz eBay page, the latter production suck in fitment now, may also be the reason why they're selling it way cheaper than it originally came out. Rest assured this one I'm selling came from the very first molds from the very first group buy Rideskinz did, here in CL. In the link, buyer #27 huNGjaii sold this to me with the SC. And you can verify this directly from him.
Brand new, never mounted and never painted. I don't know if people know about this, but according to Rideskinz eBay page, the latter production suck in fitment now, may also be the reason why they're selling it way cheaper than it originally came out. Rest assured this one I'm selling came from the very first molds from the very first group buy Rideskinz did, here in CL. In the link, buyer #27 huNGjaii sold this to me with the SC. And you can verify this directly from him.
02-10-14, 01:27 PM
#4
Banned
Join Date: Apr 2013
Location: CA
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
<<<< Rideskinz. Yeah, we've seen the feedback. I wouldn't consider it "a lot" of people giving negative feedback. Its not even that bad to begin with. Three out of 25 ain't bad. Again not here to crap on the thread. Just trying to set things straight. Have you tried to install the lip on your bumper?
02-10-14, 05:35 PM
#5
<<<< Rideskinz. Yeah, we've seen the feedback. I wouldn't consider it "a lot" of people giving negative feedback. Its not even that bad to begin with. Three out of 25 ain't bad. Again not here to crap on the thread. Just trying to set things straight. Have you tried to install the lip on your bumper?
Trending Topics
03-03-14, 09:13 AM
#8
More parts for sale
95-96 Lamp Failure - $60
Selling this if anyone is interested. I might as well get the one for the 97+ to eliminate the annoying warning light in the cluster. This is $300+ brand new. This works great cause it was lit up the entire time I had the 95-96 custom clear tail light, since I had to use LED bulbs for the brake light since it's been cleared out.
Selling this if anyone is interested. I might as well get the one for the 97+ to eliminate the annoying warning light in the cluster. This is $300+ brand new. This works great cause it was lit up the entire time I had the 95-96 custom clear tail light, since I had to use LED bulbs for the brake light since it's been cleared out.
Last edited by OG Dada; 03-06-14 at 08:58 PM.
