TX sc300 harness redone in braided nylon setup for AEM v1 and lq9 coils
#1
sc300 harness redone in braided nylon setup for AEM v1 and lq9 coils
I have a engine harness that i redid with all braided nylon sleeve and removed all vsv and o2. It is setup to run AEM with lq9 coils and bosch ev14 injectors. I will be making a new harness for my proefi setup with cannon plugs so i don't have a need for this harness anymore. It is a 97 harness so it has crank sensor plug.
Looking for 500 obo shipped.
Pictures of the harness can be seen in my build thread or you can give me your email.
Looking for 500 obo shipped.
Pictures of the harness can be seen in my build thread or you can give me your email.
Last edited by jwin; 01-24-14 at 04:06 AM.
Thread
Thread Starter
Forum
Replies
Last Post