CA SC300 10 point roll cage FT or FS
08-22-09, 09:49 PM
#1
Driver
Thread Starter
iTrader: (9)
Join Date: Apr 2009
Location: CA
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
SC300 10 point roll cage FT or FS
Okay so here's the deal. I have a 10 point roll cage installed on my 95 SC300, Im turning it back to a fully streetable Lexus. So this roll cage is up for sale or trade. I bought this vehicle off of Ben (ttandsc) on Supraforums and i think (BensSC) on here, he can attest to this cage. It was 3k$ to put in. What Im looking for, is a complete drivetrain( Engine all the way to the rear end ) as a trade. Or an up right sale of 400$. As for the powertarin etc, Im looking for either a complete 2JZGE with either 5spd or auto tranny, or a 1jzgte complete. Depending on the powertrain, either it can be an up right trade, or you will put cash ontop, or I will put some ontop, again, depending on what you are offering. I will get some pics up tomorrow. This could also be installed on a MKIV Supra, we would just have to take a few inches off the floor part on the cage. As the chassis are the same on both vehicles but the SC is a few inches taller. PM me if intersted, thanks.
Last edited by IggySupra; 09-29-09 at 09:34 PM.
09-02-09, 12:00 PM
#6
Here a few from when I had the car. The cage was FULLY tig welded, it's a chromoly cage not just a basic steel cage, with minor shortening of the cage it will fit a supra. If you guys have more questions about it that iggy cant answer just pm me.
drivers side
trunk view (cage attaches to frame)
pass side view while dash was out of car
drivers side
trunk view (cage attaches to frame)
pass side view while dash was out of car
Trending Topics
09-29-09, 09:33 PM
#14
Driver
Thread Starter
iTrader: (9)
Join Date: Apr 2009
Location: CA
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
SOrry I havent updated, been out of the forums for a bit. But anyways, I can take more pics if needed. The thickness is about 1.75" thick. As for the SCCA comment, it was on an 8 sec capable setup. 1100whp through a TH400. If anyone is interested, PM me. 400$ and ill get this out and you can pick it up. Or 200$ and come take it out and take it with you. I just wanna get this SC going again, this is in my way.
Last edited by IggySupra; 09-30-09 at 07:58 PM.
