WTB: Rear Section SC300 Driveshaft from 1992 or 1993 Vehicle
#1
WTB: Rear Section SC300 Driveshaft from 1992 or 1993 Vehicle
I am interested in acquiring the rear section of a driveshaft from a 1992 or 1993 SC300. It does not matter whether this piece comes from a 5MT or a 4AT: both are identical from the center bearing back. But, it does matter that is comes from a 1992 or 1993 since those are the only years with the driveshaft connected front-to-back by four 14mm bolts.
I have Paypal in hand, and I would prefer to acquire this sooner than later. At the same time, I do not want to overpay for a piece that has been sitting in your garage for months without a purpose. As mentioned, I only need the rear portion of the driveshaft.
Use this thread to submit your contribution, or use PM if you prefer. Donations are obviously always welcome: this driveshaft is going to a good cause (R154 1UZ project).
I have Paypal in hand, and I would prefer to acquire this sooner than later. At the same time, I do not want to overpay for a piece that has been sitting in your garage for months without a purpose. As mentioned, I only need the rear portion of the driveshaft.
Use this thread to submit your contribution, or use PM if you prefer. Donations are obviously always welcome: this driveshaft is going to a good cause (R154 1UZ project).
#4
Gazi, this sounds great.
I had another member offer me $50+shipping. But, that is going to be about the same price, I would imagine since the piece is not exactly feather weight.
You always come through when I need obscure parts.
Just make sure this driveshaft is from a 92/93 SC300. The production date on the door jamb should precede 01/94. If it does, you should find four 14mm bolts that will separate the front from the rear driveshaft. That is what I am after.
The Paypal is on its way.
I had another member offer me $50+shipping. But, that is going to be about the same price, I would imagine since the piece is not exactly feather weight.
You always come through when I need obscure parts.
Just make sure this driveshaft is from a 92/93 SC300. The production date on the door jamb should precede 01/94. If it does, you should find four 14mm bolts that will separate the front from the rear driveshaft. That is what I am after.
The Paypal is on its way.
Thread
Thread Starter
Forum
Replies
Last Post