rear window spoiler
#1
Lead Lap
Thread Starter
Join Date: Aug 2012
Location: NC
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
rear window spoiler
Anyone bought this spoiler. Looking for comments?
http://www.ebay.com/itm/92-00-Lexus-SC300-SC400-JDM-Rear-Roof-Visor-/281413369219?_trksid=p2054897.l4275
http://www.ebay.com/itm/92-00-Lexus-SC300-SC400-JDM-Rear-Roof-Visor-/281413369219?_trksid=p2054897.l4275
#3
Lead Lap
Thread Starter
Join Date: Aug 2012
Location: NC
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
#4
Pole Position
iTrader: (1)
Join Date: May 2014
Location: Orlando, Florida
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
Fits perfectly, except I messed it up about 1 mm lol because it touched the glass with the tape exposed and I couldn't get it off lol. One of my corners tape came off, but maybe I didn't clean that part enough or put enough pressure on it. I out different 3m tape on that side yesterday so hopefully it holds. However, I don't think the top corner on each side is curved to hug the glass enough, but it's not going anywhere and not very noticeable.
#5
Lexus Test Driver
iTrader: (14)
Join Date: Jun 2009
Location: CA
Posts: 1,072
Likes: 0
Received 0 Likes
on
0 Posts
prep it well, clean the fuhh out of the glass before putting it on, could also help to use a heat gun/hair dryer. My sides came up but I just squeezed in a new layer of 3m doublestick tape and all's been good for the last 2 or so years.
Trending Topics
#11
Lead Lap
Thread Starter
Join Date: Aug 2012
Location: NC
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
#13
Driver School Candidate
Join Date: Feb 2014
Location: Georgia
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
I have had mine for almost a year, I live in the south and at one point in summer it got extremely hot, and the tape that it came with started to let go. I simply replaced it with 3m heavy duty double sided tape and all good now. I recommend using 3m and a heat gun or hair drier from the get go.
A also i got mine from Amazon, its the same style though.
A also i got mine from Amazon, its the same style though.
Amazon.com: LT Sport C2DLSC3009200 for Lexus SC300 2-door Coupe Rear Visor/ Wind Deflector/ Spoiler: Automotive
#15
I'm assuming to heat up the double sided tape that will be on it already when you open the box. I installed mine with a buddy and it literally took 30 seconds. No heat gun and it was probably 60-65 degrees. No issues at all. It will be a tiny bit off in the very center of the spoiler. It won't be completely flush with the weather stripping all the way cross at the top of the rear window. And there is no way getting around that. Its just how it is. Just make sure your corners are where you want them during install and stick the center down last!