My 1998 SC400
03-31-14, 08:09 PM
#32
Looking good man!! In your honest opinion, did you feel any weight savings difference between the two tranys or no? And how's the clutch pedal feel with the htb firm soft?...
Snap a pic of your dshaft tail end and a trans output shaft area if you can
Thanks!!!
Snap a pic of your dshaft tail end and a trans output shaft area if you can
Thanks!!!
04-07-14, 06:29 PM
#33
Driver
Thread Starter
iTrader: (1)
Join Date: Dec 2008
Location: ok
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for the late replies!
To be honest the clutch I'm using us a stock clutch exedy stage 1 or pretty much oem replacement for the w58
The pressure plate I am using is 3sgt from mr2 also oem replacement for that car
The pedal pressure is alright it's not stiff or too soft.
If you upgrade the pressure play you'll deff feel the difference but remember that if you do make sure your throw out bearing can handle it.
I've been busying and haven't had the chance to throw the car on the lift yet
Just wondering what your looking for as far as the diff/drive shaft goes?
To be honest the clutch I'm using us a stock clutch exedy stage 1 or pretty much oem replacement for the w58
The pressure plate I am using is 3sgt from mr2 also oem replacement for that car
The pedal pressure is alright it's not stiff or too soft.
If you upgrade the pressure play you'll deff feel the difference but remember that if you do make sure your throw out bearing can handle it.
I've been busying and haven't had the chance to throw the car on the lift yet
Just wondering what your looking for as far as the diff/drive shaft goes?
07-22-14, 07:36 PM
#34
Driver
Thread Starter
iTrader: (1)
Join Date: Dec 2008
Location: ok
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Small video up date. Not much. I ended up blowing up my MK4 trans due to it being already on it's way out lol. But I got a 92-94 trans which you will need to cut atleast another 1-2 inches from the existing hole. Which the 92-94 shifter bends back anyways.
View My Video
View My Video
07-22-14, 07:38 PM
#35
Driver
Thread Starter
iTrader: (1)
Join Date: Dec 2008
Location: ok
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Here's a link just in case that other didn't work. I'll try to get more video footage when I get time between work and my other car 
http://tinypic.com/r/sqk31s/8
http://tinypic.com/r/sqk31s/8
Last edited by asianrob; 07-23-14 at 10:33 PM.
10-12-15, 04:55 AM
#36
Driver
Thread Starter
iTrader: (1)
Join Date: Dec 2008
Location: ok
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
It's been a while since I posted anything but I just got hurricane headers in stalled, 2.5 inch piping and GT500 X pipe, so here is an idle video, no cats, no resonators View My Video
Thread
Thread Starter
Forum
Replies
Last Post
