Luxor

iTrader: (15)

This is a great idea, I don't know why I forgot about this.

96blksc300

Hmm that doesn't look bad

Tabaka

iTrader: (8)

I bought the same LED's as you suggested and they are much smaller than the bulb "housing". They practically rattle inside so I took them out. How did you get yours to stay inside the bulb housing tightly?

SuperbrightLED's doesn't take returns so I'm out $30 bucks

Should have gone with my gut and just sent this cluster away to Lextech.

DoomLight

iTrader: (3)

U have to bend the pins in the connectors so they grab the bulb better.

1JZPWRD

iTrader: (59)

I also went with suoerbrightleds. I was overall impressed with the quality of bulbs but i also have hot spots. The same positions as yours. Overall it looks good and i can live with mine.

Tabaka

iTrader: (8)

ah... I see, I see.

Since the LED's have negative and positive polarity, did you simply install them and have a little trial and error demo before getting them all to light?

DoomLight

iTrader: (3)

yes. thats why i have a pic of my cluster without the face. i had to swap the bulbs around so they connected with the correct polarity

94_soarer

iTrader: (8)

Hey Doomlight, will you do my cluster, i cant meet up with you...lmk pm me

2jznosht

my superbright led's for the cluster just got here today, as did my needles. heres hoping it all goes smoothly this weekend

DoomLight

iTrader: (3)

i'll have to show u first. get ur opinion. not everyone may like my results.

94_soarer

iTrader: (8)

^^^ Yea, just lmk but im pretty sure it will come out great, alot better then factory & thats completely fine with me...Im not to **** about it like these other guys out here.. PM me ur #

Tabaka

iTrader: (8)

what needles? Where did you get needles?

MattStarr

If you guys knew how to solder in resisters you could use these
http://www.superbrightleds.com/morei...llilumens/341/
I just put these in my cousins cluster and guess what...... no spots

DONT SLEEP

iTrader: (8)

Anyone else try this mod? For the bright spots... has anyone tried putting some hot glue over the LED to diffuse the light?

1JZPWRD

iTrader: (59)

I used the reflective tape on the inside of mine. The kind people used on AC duct work but without the lettering. I had to cut several small pieces. The results were alot better, I also. It was not perfect, but it was alot better and well worth the effort. Just peel and stick on the white plastic. Good luck.