When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Oh, I didn't realize your air bag didn't have that plug. Your best bet would probably be to solder the wires.
Has driving your SC without an air bag given you any trouble?
you mean like turning off when at idle? lol. If so, then yes. I don't think that effects it though. Lots of people get Nardi or aftermarket steering wheels and don't have issues.
bump!!! mortal did you keep the sc hub? and what did you do to connect the horn??
I also replied to your response in the IS300 wheel thread. I will here too. I installed an IS200 wheel onto my 95 sc400 not too long ago. I left the SC hub on, and bought the airbag sub harness connector to adapt the SC clip to the clip on the IS wheel. I also cut the wires for the cruise control because I don't use it.
connector adapter is part number 09082-00760. I bought it from handsontools.
For horn, just cut the wire that I think is riveted to your SC wheel. Install a female spade terminal, and connect it to the male tab on the celica wheel (you will see the male tab in your pic of the celica wheel in the IS300 thread)
I also replied to your response in the IS300 wheel thread. I will here too. I installed an IS200 wheel onto my 95 sc400 not too long ago. I left the SC hub on, and bought the airbag sub harness connector to adapt the SC clip to the clip on the IS wheel. I also cut the wires for the cruise control because I don't use it.
connector adapter is part number 09082-00760. I bought it from handsontools.
For horn, just cut the wire that I think is riveted to your SC wheel. Install a female spade terminal, and connect it to the male tab on the celica wheel (you will see the male tab in your pic of the celica wheel in the IS300 thread)
well I got the connector worked out soldered 2 pigtails together so save 30 bucks.
and in terms of the horn, can you save the pic of the sc400 wheel I have posted, go to windows paint and draw a line to what I need to do for the horn??
yes, that's what I did. Just snip them in the middle of the wire length just in case you ever wanted to re-install it
After snipping the wires, individually heat shrink the ends of the wires to insulate them. Also, I disconnected the battery while installing the wheel because some people have mentioned the airbag light coming on if the airbag harness was disconnected while battery still on.
09-12-11, 11:26 AM
