NEbiker10

iTrader: (1)

I have a spare set of 9006 HID. I figure I might as well use them in my corning lights. I wanted to find out how I could retro fit them. I came up with a few ideas but this one seem the most solid. Here we go. Junkyard is a must.

Go to the junkyard and find a headlight/fog that is 9006 and has a similar curve to it.

Drill out the top hole with this.



Do the Same on our corning/fog light. make sure its the same angled cut. Then take the 9006 one and secure it somehow to our light. I figured Hot Glue or epoxy. Maybe even heating up both plastics with a blow torch and fusing then together. This way you would have a perfect 9006 retro fit.

Klaus

iTrader: (1)

........

ShiftyD2k

iTrader: (18)

i already mod my car cornerlight hid and it's look weird to me so i put back jdm yellow bulb better...

iridebmx

iTrader: (6)

heh?.... i dont get the concept

aznxenon

Do it! Except I'm currently under the influence so I'm not exactly sure what you're actual plan is. Regardless, do first, think later.

turbodremz

iTrader: (18)

Already did a retro fit on the factory cornering laps with fogs, but I did it the "right way" and actually stuffed a fog light assembly into the housings.

NEbiker10

iTrader: (1)

Almost like this

Bender25

iTrader: (10)

Do what I did and just retrofit an ES300 foglight into the cornering light housing

skirts

iTrader: (1)

Do you have a diy or pics?

Klaus

iTrader: (1)

Why not pick up a set of 95 fogs?

turbodremz

iTrader: (18)

^^95 fogs dont fit the pre-95 bumpers.

Bender25

iTrader: (10)

here it is on-



And here you can see the projector in the stock housing-

kyddo112

is aimed at an angle or straight ahead?

nivek5sfe

sounds like a plan. go for it. we need more options for these lights

i was just going to use a hole saw like that on the light housing , mount an aftermarket foglight, then slide the light housing over the fog light.

Klaus

iTrader: (1)