What did you do to your SC today?
#5102
Driver School Candidate
Installed my junkyard headlight and polished both of them. No sandpaper required. Just a regular electric polisher, foam pad and rubbing compound. I followed up with polishing compound but really couldn't see a difference. Also installed the rebuilt power steering pump, alternator, and rack and pinion that I got from the pick n pull. It was a messy messy job as the PS pump and rack have been leaking for quite a while. In a few weeks, I will get to the transmission mount and center support bearing.
#5105
Driver School Candidate
Join Date: Dec 2014
Location: WA
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Installed the rear G35 Rays 19" wheels, noticed my suspension back there looks a little on the shot side. Going to take off the fronts and start doing the necessary mods for the LS400 BBK install, and also probably find out I need new LCAs too.
#5107
Driver School Candidate
Join Date: Sep 2014
Location: CA
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Got an alarm installed today. $120 installed for a 1-way alarm.
Also Changed my PS high pressure hose a couple days ago. Company called 3sx who i used to buy parts from when i had a Mitsubishi 3KGT back in the day. Looks great and costs practically the same as driftmotion's. All black
Also Changed my PS high pressure hose a couple days ago. Company called 3sx who i used to buy parts from when i had a Mitsubishi 3KGT back in the day. Looks great and costs practically the same as driftmotion's. All black
#5111
What I did / had done in the month of Jan. to my 93 SC 400. 163k
*valve cover gaskets
*fuel pump
*fuel sending unit
*fuel pump ecu
*fuel filter
*starter
*complete timing kit
*idler pully
*accessory belt
*upper & lower rad hoses
*steering rack
* added a dash cupholder
This baby should be good for another 100K
*valve cover gaskets
*fuel pump
*fuel sending unit
*fuel pump ecu
*fuel filter
*starter
*complete timing kit
*idler pully
*accessory belt
*upper & lower rad hoses
*steering rack
* added a dash cupholder
This baby should be good for another 100K
Last edited by Bankswood; 02-05-15 at 06:32 PM.
#5112
Driver School Candidate
1993 SC400. Bent my trans oil pan a little while trying to remove it (in order to replace the strainer). It was rtv'd on really hard and was seriously tough to get off. Now wondering if I should try to pound it straight or just replace the pan!
#5115
Pole Position
iTrader: (1)
My throw out bearing came in a few days ago, and my custom mounting plate to to mount it to the 1uzfe bellhousing adapterto the bearing from exessive manufacturing.com came in, so I bolted everything up to see how it would match and it's dead on!!
I still have some adjustments and some measuring to do, to get this bearing with in 1-2 mm away from the clutch plate fingers, and then it's a hunt for the w58 front shaft, that would be my last piece or I can just go all out and go aluminum we'll see who knows... Here are a few shots of what I'm working with.
I still have some adjustments and some measuring to do, to get this bearing with in 1-2 mm away from the clutch plate fingers, and then it's a hunt for the w58 front shaft, that would be my last piece or I can just go all out and go aluminum we'll see who knows... Here are a few shots of what I'm working with.
Last edited by LEXXIUM; 02-07-15 at 07:47 PM.