What did you do to your SC today?
#4292
Driver School Candidate
Join Date: Dec 2013
Location: Hungary
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
#4296
Pole Position
After the radiator hose burst and sprayed coolant all over, had to remove the hood liner (what a PITA that is...) and rinse it out.
Appears it will take a couple of days to dry (even after "pressing" a lot of water out of the insulation) before it gets re-installed.....
Appears it will take a couple of days to dry (even after "pressing" a lot of water out of the insulation) before it gets re-installed.....
#4300
Intermediate
#4303
I replaced the front struts! Never done anything like this before, so it was a challenge. The right side took me quiiiiiite a while (longer than I'd like to admit). But with that I learned, I was able to replace the driver side in just under 2 hours from start to finish.
Attachment 498008
Sad part is, left rear is almost all the way flat due to leaving only the front right lifted for way too long. And the lug nuts are rounded off, can't remove the wheel as is. Bah!
Attachment 498008
Sad part is, left rear is almost all the way flat due to leaving only the front right lifted for way too long. And the lug nuts are rounded off, can't remove the wheel as is. Bah!
#4304
Driver School Candidate
Join Date: Nov 2013
Location: HI
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Denso Iridium plugs arrived today! Install coming Saturday
Cant pull the trigger on knock sensors.. trying to find good source for Densos.
'98 400, Plat/Met adopted two weeks ago! its got a decent list of touch ups needed but I look forward to doing them!
Cant pull the trigger on knock sensors.. trying to find good source for Densos.
'98 400, Plat/Met adopted two weeks ago! its got a decent list of touch ups needed but I look forward to doing them!
#4305
Driver School Candidate
Join Date: Jan 2014
Location: rus
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Installed in the car CUSCO struts, front 4pot calipers, new front brakes.
Faced with the problem of tightening the nuts on the lower front arm. On both sides. Car dropped a couple of inches.
I apologize if I write with mistakes, if somebody will correct me how to write, I will be very grateful
Faced with the problem of tightening the nuts on the lower front arm. On both sides. Car dropped a couple of inches.
I apologize if I write with mistakes, if somebody will correct me how to write, I will be very grateful