Davidddd

iTrader: (1)

Found a good condition rear floor mat at my local pick n pull!

sr71b

attempting to figure out why my passenger sidemarker does not work :/

robtackett

iTrader: (1)

Well picked up car on wed and got this last night for it.

xspsi6

iTrader: (31)

Ooh what bulbs did you use for the volume and temp *****? I have been wanting to fix mine to match my cc for a while now!

1of120

iTrader: (9)

got it ready for lexus evolution.

Harbinger

Contemplated putting on the heavya** door(that I got for a steal thank you very much) & decided I would rather do it tomorrow... does that count? lolz

soarer13oy

iTrader: (13)

Same here!

pieisgude

iTrader: (2)

Parked her, again. Right after i installed new contacts in the starter, i drive off and get a flat tire 1/4 of a mile down the road. =(

scshinobi

iTrader: (3)

new wheel bearing in front only


Dont take out the metal sleeve, you need to cut the outer part out, Prothane or JEGS are worthless when it comes to helping with this issue... Had the run around for a couple days before the guy tells me from the pictures and measurements i can use it with the metal sleeve in... SMH why the hell would you make it so difficult....



foreplay

scshinobi

iTrader: (3)

and i realized how difficult it is to wind the window regulator by hand..... it is not going to happen, the wire is getting effed SMGDH

OG Dada

iTrader: (10)

schinobi, I don't mean to be rude, but dude you've been here since 2008, and a lot of members have already said not to take out the sleeve for the FLCA if you use Prothane and still made the same mistake? Can't really blame it on the company, it is written on the instructions, and a lot of detailed DIY's available here in CL, including mine, which is the most detailed I've seen by far, just gotta do a thorough research next time you try to do something you have never done before so you wouldn't encounter anymore surprises like this... Good luck. And check my build thread in case you plan on doing any more bushings. There's gonna be a lot more stuff that might surprise you.

chrisindub

iTrader: (1)

I don't remember wheel bearings having bushings. That second picture looks like a lower control arm bushing.

I let my GF take my SC to work today, I know I am going to regret this...............

Cebo

Ended up tightning down seat nets, sanding down headlights, and more dreaming about the manual swap haha.

sayayin

iTrader: (2)

Ah what PITA, but my car is alive again, took me 3 weeks, to swap my side feed injectors to top fuel setup on my 1jz, if I have to do this again motor has to be outside the car or pay a professional to do it.

LEXXIUM

iTrader: (1)

Nice pick up on the vvti! I'm here in Indy and looking for the same where did you go to get it please tell?

Thanks