MIGS

iTrader: (15)

removed my wheels(sold em) and left the car on 4 jack stands.

because i refuse to put the ugly oem ones back on, lol

kapetajr

iTrader: (3)

LMAO..... pics or it didnt happen

Tament

Dropped a new Nav unit in over the weekend. Not totally loving the sound, as the base is not as the stock was, could be bad wiring, checking that out this weekend, ran out of time, so did not take it apart and check.

socal72

iTrader: (8)

Looks good. Do you mean that there is no bass coming from the sub? Do you have a aftermarket sub and amp? Or are you using the the factory set up. If you have the Toyota harness that has the RCA's for the front and rear channels then you will not be able to have a sub signal unless you wire into the factory sub amp.

ArodDaLob

iTrader: (14)

installed new plugs, wires, distributor rotor/cap, motor mounts, and tried to reinstall the tranny, but was too tired to match up the splines

CrispyST3

iTrader: (1)

Well first i want to get it back from the body shop after some lady hit me. And then get some tein basis coil overs and some gold XXr 521's. 18x 8.5 in the front and 18x10's in the back. I want to put 95 tail lights on them and switch over to the 97+ bumpers and sides. Drop a 2jzgte and tune it for drift. Some how get my hands on a GETRAG transmission. Do some interior work some electrical work. I want to do a push start button and other stuff i just have to think of it lol

Tament

I am using factory amp and sub, with the Toyota wire harness. When they asked me if I had the Nak system, I thought it would be plug and play, and all would be same as with the factory radio. I was hoping to keep it stock for the most part...But I may have to put some after market amps in and go from there. That wire harness is a piece of crap,

2BENVD

iTrader: (1)

Installed coilovers

2JTsc300

just bought my AEM EMS for my NA-T build

MIGS

iTrader: (15)

lol well i guess ur just not gonna believe it happened, cause i ain't takin any pics of that ugly sheeyat right now.

socal72

iTrader: (8)

Yeah that's what I did to mine( used aftermarket amps) and it sounds tons better.

DoomLight

iTrader: (3)

installed coil spring spacers to raise my car 1.5 inches all around since my lowering springs were too low. car no longer rubs now. woot!

Drunkinche

Powdercoated my clutch master cylinder bronze and installed it with new internals

2JTsc300

i fixed my trunk switch finally

poorsupra

iTrader: (11)

battery relocation, soarer steering wheel install. built a battery box, painted my soarer badges and 97 grill.