What did you do to your SC today?
#5431
Driver School Candidate
Join Date: Jun 2014
Location: Ga
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Made a Pontiac g8 go run and hide, he came by revving up at me when traffic was tight, caught back up to him with a clear road and gave him a taste of what a cammed t67 gte can do, did not take long for him to be in my rear view mirror where I saw him get smaller and smaller ha ha
#5432
Lexus Test Driver
iTrader: (2)
Did a bunch of stuff trying to get my parts car started. It fired up for about 2 seconds before dying after giving it gas. Ignition coil connector crumbled when I touched it so I gotta go to junkyard tomorrow and cut one off another sc. I did the 12v mod and was quite pleased when I saw this...
Then after the 12v mod I checked the ECU for leaky capacitors and found more...
Everything is Dynamatted real well. It's getting harder and harder to call it a parts car, this is looking like my new project. At the end of the day when I was wrapping everything up it hit me... the car being lowered and all to check the drivers side wheel well for rubbing. Sure enough a big chunk of plastic is rubbed out, and I see the wiring. Unfortunately the car is so low I couldn't get a good look at it, but at some point tomorrow I'll have her up in the air for a better look. I really hope I get it started soon.
Then after the 12v mod I checked the ECU for leaky capacitors and found more...
Everything is Dynamatted real well. It's getting harder and harder to call it a parts car, this is looking like my new project. At the end of the day when I was wrapping everything up it hit me... the car being lowered and all to check the drivers side wheel well for rubbing. Sure enough a big chunk of plastic is rubbed out, and I see the wiring. Unfortunately the car is so low I couldn't get a good look at it, but at some point tomorrow I'll have her up in the air for a better look. I really hope I get it started soon.
#5434
Lead Lap
iTrader: (8)
Flogrown, is that a CF wrap or an actual insert? I'm planning on doing my hood in a two-tone like that, but probably with flat black on the raised center portion to match the top section of my trunk and spoiler. The CF looks awesome as just part of the overall hood, though. I've seen a computer generated SC like that previously.
#5435
Small details; just added some chrome molding along the hood and trailing to and around the headlamps to accentuate that angled look all the new models have and add a little something to the front appearance
#5440
Lexus Test Driver
iTrader: (8)
I think the best look for CF is a ghost fade though, but that's just me. It should always be re-cleared though, otherwise may as well stay stock.
#5441
Driver School Candidate
Join Date: Mar 2015
Location: Tx
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
worked on the Ls400 engine thats replacing my blow sc motor....the guy forgot to send my new(ish) sc400 oil pan along with the motor , gotta go back to Houston tomorrow to pick it up and a couple other spare parts.
#5443