What did you do to your SC today?
#4546
Bought some knock off seats from gbay and got an awesome deal on these and thinking about installing in my sc instead if the fj80 yeah.. Go figure What do you guys think? Yei or nay in my sc?? Quality, by looking at it is great for fakers and this is the first actual buy from gbay I'm thrilled about!!! I'll update the pics in a few
#4549
Lexus Champion
installed poly diff bushings without taking the diff out, it was a challenge cz my mechanic friend is a typical lazy mechanic lol. cut the fuel pressure regulator wire for the auto trans, car shifts mad awesome now. looked into the ECT sensor, kinda hard to get to it because i can't take my intake house out because i have a strut brace. wired some interior LEDs in for the footwells, need to move em back further cz you can still see them. car is rust free now! just lots of touch body work and then going in for paint and plastidip
#4550
cleaned the new pearl sc
just purchases her, had a 99 black /black. sold it! (i know I know) 3 years later found this 00' pearl white gem and did not pass her up. She stays in the garage, I just sat in her cleaned the dash and conditioned the seats,
#4552
Driver School Candidate
Join Date: Sep 2013
Location: Arkansas
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Dude my sc400 has a SC300 instrument panel, don't trip on what my needles say. I don't know what's normal, I do know my tach reads way below what the engine actually is doing...
#4553
In Recovery Mode
iTrader: (11)
Replaced the tires with some high-performance Kuhmo Ecstas (I think). While I was at it, I swapped the rims from the stock spoke rims to some 18' RX8 rims. Spacers would make it fit better, not that far yet. Please excuse the dirt and brake dust on the wheels, it will be cleaned!
#4556
Driver School Candidate
New springs
Added B&G springs on the front. Since their for a supra I have to replace the rear struts.THIS THING WENT BEYOND WHAT I THOUGHT! Almost 2.5 inches lower. Can't wait for the rear to drop!
#4557
Lexus Test Driver
iTrader: (2)
Removed the heat shield that was rattling due to the rusted spots breaking on one side. Nuts were rusted so bad I had no choice but to break it off, which was very easy.
Cleaned the entire engine bay since Toyota left it pretty dirty after doing my timing belt. Also cleaned my oem wheels, they shined up pretty nice with simple green. While I was at it I cleaned a few things that usually go untouched but needed attention like inside the gas cap area, and I put the sunroof all the way back and cleaned inside there as well as lubed the tracks.
Cleaned the entire engine bay since Toyota left it pretty dirty after doing my timing belt. Also cleaned my oem wheels, they shined up pretty nice with simple green. While I was at it I cleaned a few things that usually go untouched but needed attention like inside the gas cap area, and I put the sunroof all the way back and cleaned inside there as well as lubed the tracks.