chicos

need help on how too remove tail-light to replace reverse lamp-blub. pictures would be great.

good2go

iTrader: (6)

Just peel back the trunk liner and there's three 10mm nuts you need to remove (don't drop them!) and it should pop right out.

Dx3

iTrader: (13)

May need a deep 10mm. I thought there were 4 nuts?

Jonny

good2go

iTrader: (6)

oh snap...you're right!

I must have dropped that 4th one

BostonSC4

iTrader: (2)

Peel the rug back, theres a few clips holding the rug to the car. While doing that, use a 10mm socket to get those 4 nuts off for each taillight and once you do that the whole unit will pop right out. Goodluck.

FuMoFFuTT

iTrader: (2)

Also the lock mechanism for the trunk is easy to figure out. I forgot what you need to remove it though, a screw driver? lol

1JZPWRD

iTrader: (59)

While you got them out, I would paint them or something! JMO, if you havent already.

AngelBaby

This worked great!... until I ran into 2 more nuts I had to take off :|

Dx3

iTrader: (13)

2 more For what? The trunk locking mechanism?

Jonny

Kira X

iTrader: (24)

The trunk lock has two extra bolts. It's probably for that.

AngelBaby

Well, I have an SC4. And I'm not sure if it's the same for the SC3, but to remove the tail lights there are the 3nuts around the trunk lock mechanism and two more on the side of the tail light... Eeee explanation seems winded. But makes sense yah?

Dx3

iTrader: (13)

LOL - it seems everyone is, for the most part, in agreement. Technically there are 4 bolts holding the tailight in place, leaving 2 for the trunk lock mechanism... So 6 total, or apparently 5 with your math skills

Jonny

AngelBaby

Errr wow I'm r-tarded. Yes you guys are so right. I totally had a blonde moment :/ how s-a-d. -drinks more coffee-