1UZ Crank End Table
12-27-13, 12:05 PM
#1
1UZ Crank End Table
You guys saw my thread about the 1UZ coffee table. Well this is what I decided to do with the crank. As a ex motocross racer. I thought a Renthal sprocket design would be cool for the top & the bottom. The bottom is 3/8 304 SS material. Its about 12" in diameter. The top is 6061 aluminum & is about 19" in diameter.
12-27-13, 10:26 PM
#3
Bam!!! That's sweet!!! Love the mechAnical creativity man, great job!!
Not sure about the white though
Oh what kind of parts are you making there on the table??
I bet you can build a good cold airbox for the sc and bunch of other cool stuff
Not sure about the white though
Oh what kind of parts are you making there on the table??
I bet you can build a good cold airbox for the sc and bunch of other cool stuff
Last edited by LEXXIUM; 12-27-13 at 10:29 PM.
01-10-14, 01:45 PM
#5
Thanks man! Lol its not white. Its just looks that way in my crappy pics. I ran it through the "time saver" sander. So it has that brushed stainless steel look. I probably should have just done SS on the top, but I was worried that it would be too top heavy & fall over. That crank is about 60lbs...
Thread
Thread Starter
Forum
Replies
Last Post