Ultimate SC/Soarer Picture Thread
#140
Lexus Test Driver
iTrader: (5)
This kit is nice, but I wonder how the car can be jacked up or towed if it has a flat tire. It has wide side skirts so I don't think a conventional jack can be put underneath even if it's a long handle jack. I have a JIC kit and it's already a problem with the flat bed towing truck. And when I jack it up, I have to use a very low jack.
#144
Pole Position
iTrader: (1)
Join Date: Dec 2008
Location: Ontario, Canada
Posts: 274
Likes: 0
Received 0 Likes
on
0 Posts
This kit is nice, but I wonder how the car can be jacked up or towed if it has a flat tire. It has wide side skirts so I don't think a conventional jack can be put underneath even if it's a long handle jack. I have a JIC kit and it's already a problem with the flat bed towing truck. And when I jack it up, I have to use a very low jack.
#145
Lexus Test Driver
iTrader: (5)
its not too hard. all you need to do is always bring 2-4 wooden planks. most of my drift buddies ride about an inch off the ground or even lower. we just drive onto the wooden planks the put the jack underneath. sometimes we have to do it twice depending on how low the car is. also for flatbeds a guy that had to tow my friends r33 gtr told us a secret. after the hooks are attached put a large enough plank between the chain and bottom of your rebar. this will prevent the chain from hitting the front lip and will allow the flatbed to pull the car without damaging the front.
#146
Lexus Test Driver
iTrader: (33)
Join Date: Jul 2004
Location: Sideways on the Yellow Brick Road! < Thats KS!
Posts: 5,827
Likes: 0
Received 4 Likes
on
4 Posts
its not too hard. all you need to do is always bring 2-4 wooden planks. most of my drift buddies ride about an inch off the ground or even lower. we just drive onto the wooden planks the put the jack underneath. sometimes we have to do it twice depending on how low the car is.
#148
Lexus Test Driver
The red soarer on page 8
BN Sports Blister, correct?
I wonder where I can get this kit from.
wait wait, just looked it over.
It's not. lol.
I wonder if the rear quarters are custom w/ ridge body parts?
man, i need to pin point this!!!!!!!!
BN Sports Blister, correct?
I wonder where I can get this kit from.
wait wait, just looked it over.
It's not. lol.
I wonder if the rear quarters are custom w/ ridge body parts?
man, i need to pin point this!!!!!!!!
#149
the rear is custom im pretty sure. the front looks like the same body kit off the grey one Vertex Ridge widebody?...i would customize the front fender..never liked the gill fish looking.
Last edited by SC34M3; 10-19-09 at 12:51 PM.