Yeah, in the beginning, the door side moved, because the center console side wormgear was out. Got the wormgear back in, capped on both sides (door sides was still good). manually set both sides ALL the way back so they would be even. Then when I press to slide, I can hear the motor trying to move it, but no joy, it just stops like they're stuck.
Might just need some fiddling, obviously something has changed when I put the cap back on.
TLDR: No sides moving now, but the motor is TRYING to get them to move, both sides still capped.
Probably happened when you manually moved it back. I would try manually moving both sides to where they were or the middle of the rail and try it again. just a guess but you may have gone past where it goes normally with power. Even if its a little crooked its not a huge deal, I think it straightens out when you use the power to get to the end of the rail if you are close enough.
Originally Posted by Tam4511
i purchased the plugs off cruser parts and pulled my seat out only to find that they dont fit, the plug that is in my other worm gear is short and wide. i need a part number!
yeah no one has ever found any part numbers, this maybe a junkyard sort of thing or sacrifice a ripped up set of seats.
Remember if your seat stops sliding, immediately go on a plug hunt before it gets lost forever.
Just like if you are rolling down your window and you hear the famous crunch, don't keep going because that breaks the rod inside the door and then you have to replace the whole door lock actuator instead of just the plastic clip. Just one of those SC things.
This ad is not displayed to registered members. Register your free account today and become a member on Club Lexus!
1995 Lexus SC300 5spd Na-T ( TT Ecu Mod + a few others)
hey whats going on everybody.So ive had this same problem only one side moves forward so i took my seats out to try and put the lil white plastic piece in but it was already in on both sides.I have no idea what to do and where to start i would love some help please