Replacing passenger side high beam
#1
Driver School Candidate
Thread Starter
Join Date: May 2007
Location: IL
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Replacing passenger side high beam
How do I remove my bumper to replace the high beam assembly on my 99 sc300? I was told this needed done in order to replace the glass that is broken over the top of the high beam.
Also, do I need a replacement from years 97-00? I also read that 92-96 won't work in a 99?
Thanks
Also, do I need a replacement from years 97-00? I also read that 92-96 won't work in a 99?
Thanks
#2
Former Sponsor
iTrader: (147)
i have a glass highbeam for sale, 50 shipped.
to take otu the bumepr, you need to pull the headlights, out, remove the rubber peice on top of the bumper, take out 5-6 screws on top, remove the plastic guards on the bottom, and the sides.
pretty simple to do, but time consuming.
to take otu the bumepr, you need to pull the headlights, out, remove the rubber peice on top of the bumper, take out 5-6 screws on top, remove the plastic guards on the bottom, and the sides.
pretty simple to do, but time consuming.
#3
Driver School Candidate
Thread Starter
Join Date: May 2007
Location: IL
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Do you have the glass only or the entire assembly? What year is it from and is it the passenger side?
I take it the headlights are too hard to take off either? After I remove the screws the rubber piece and the plastic sides, it should come right off? I do have to do this to get to the high beams, right?
I take it the headlights are too hard to take off either? After I remove the screws the rubber piece and the plastic sides, it should come right off? I do have to do this to get to the high beams, right?
Thread
Thread Starter
Forum
Replies
Last Post