bigwes

decided to wrap my center console. it was one of those spur-of-the-moment kind of things. I was really bored so I did it.

https://fbcdn-sphotos-g-a.akamaihd.n...31106052_n.jpg

https://fbcdn-sphotos-e-a.akamaihd.n...94232088_n.jpg

https://fbcdn-sphotos-b-a.akamaihd.n...21094563_n.jpg

broncofan2

Care to share with us what you used, and how you did it?

Tabaka

iTrader: (8)

I don't know why but I was thinking you somehow wrapped the entire center console lol.

Midengtoy

iTrader: (3)

Looks good but it also looks damaged already? Wrap the radio and the door trim it'll flow much better.

veritek

Hey, that turned out really good. Good job.

veritek

Agreed, maybe when your bored again

ShiftyD2k

iTrader: (18)

Look nice cf...

SC400slide

iTrader: (11)

Yea, it looks damaged...? The rest looks great.

Harbinger

3D vinyl? Looks good. What brand did you use?

1JZPWRD

iTrader: (59)

Not a big fan of the look but you have pulled it off. Not bad. Any more pieces being done?

bigwes

The actual console had some small heat damage and I was hoping it wud hide it a lil better but it didnt do that the actual wrap was ok.

bigwes

I used the 3M scotchprint.

bigwes

I'm not wrapping the radio cuz I'm putting a Double Din the summer. I'm still thinking about the other parts. The reason why I wrapped only that part was because it was black. What I might do is go to a junkyard and find a shifter console that isn't damaged and wrap that since I still have some leftover.

bigwes

I took the shifter console out which was very easy. It jus pops out. Unscrewed the two screws that hold the *****-matic together. Pulled it off, then the console will come off.

The hardest part is trimming around the P,R,N,D,2,L on the console. Be careful not to cut to close or u will scratch it. U may want to trace around the body of the shifter console to make it easier on u. Make sure u use a heat gun/blow dryer. I jus uses my moms blow dryer. U will also need a credit card to tuck the edges in.

To do the cig lighter cover is easier than I thought. I even had my gf help me cuz I thought it wud be more difficult but it took like 30 seconds. I measured a piece around the cig cover and then cut it a little above the tracing line. Then I applied it on and tucked it in the tight corners. I didn't even have to use my gf blow dryer to stretch it all.

golf007

iTrader: (1)

Looking nice