Photoshoot from the weekend! (56k lots of pics!)
#18
Pole Position
iTrader: (3)
Jordan and Grant give me pretty goos hookups. Plus I get a nice discount for being in the military. But there prices for parts are usually cheaper than the competetors plus they price match too.
Thanks everyone for the positive feedback!
Wheel specs are:
Enkei RPF1 in SBC finish
18x9.5 18x10.5 +15
Front 235 40 245 40
Lowerd on megan racing ez coilovers
Thanks everyone for the positive feedback!
Wheel specs are:
Enkei RPF1 in SBC finish
18x9.5 18x10.5 +15
Front 235 40 245 40
Lowerd on megan racing ez coilovers
are your fenders rolled or pulled?
#24
Lead Lap
Thread Starter
iTrader: (2)
Join Date: Jul 2011
Location: Kansas & Illinois
Posts: 529
Likes: 0
Received 0 Likes
on
0 Posts
They are rolled. they might have a slight pull on them from the fender roller but if it is its not much there is still plenty of room i love the lil poke in the rear.
haha ya never know now days i know people that still have dial up internet. i figured i would give someone the heads up lol.
the eaton isnt installed yet i was about to install it but found out that the pulley wobbles when i spin it. so either the pulley is bent or its the shaft. so i gotta figure out whats going on with it.
I abosolutly love this car with the 5 speed. The car pulls alot harder and is very tail happy. I can't wait to have the supercharger installed!
Thanks Again for the positive feedback!!
haha ya never know now days i know people that still have dial up internet. i figured i would give someone the heads up lol.
the eaton isnt installed yet i was about to install it but found out that the pulley wobbles when i spin it. so either the pulley is bent or its the shaft. so i gotta figure out whats going on with it.
I abosolutly love this car with the 5 speed. The car pulls alot harder and is very tail happy. I can't wait to have the supercharger installed!
Thanks Again for the positive feedback!!
#29
Lead Lap
Thread Starter
iTrader: (2)
Join Date: Jul 2011
Location: Kansas & Illinois
Posts: 529
Likes: 0
Received 0 Likes
on
0 Posts
Yea the m90's are easy to get ahold of the only bad part is the pulley is custom made so i would have to send it to a machine shop and get one made in CNC BILLET but other than that it should be easy but this one is ported and what not.