so what got a rideskinz lip!!!???
11-18-11, 10:28 AM
#62
I just did a test fit (no screws used, only tapes) so I thought I should share. I've tried to do a comparison of before and after on few shots. Please keep in mind that these were taken to get a overall feel of what it's going to look and detail close up shots will follow once the lip is painted. **passenger side is not secured 100% in these pictures.
Now on to the photos.. (I apologize for my finger appearance on few of them
)
Now on to the photos.. (I apologize for my finger appearance on few of them
)
12-28-11, 02:20 PM
#71
I finally found some time to wash my car and take some pictures. Enjoy. And just a FYI, this Fujin lip was shortened on both ends as well as trimmed/cleaned around fog light edges and molded onto the bumper with seams intact to suit my taste.
Front view:
Lower angle (Lexus emblem was removed in favor of Griffin
):
Side view with different angles, showing how the lip flows with 97＋side skirts (please disregard the 4x4 fender gap, I'm getting Tein coilovers this week.):
A close up of trimmed/shortened end of lip (please refer to previous post with picture for reference.):
Smooth transition from lip to bumper while retaining character line:
Fogs light edges cleaned up:
More molding (I didn't do a good job on wiping water off
):
Driver's side:
Close up:
Driver's side side view (there's a French bulldog in the reflection
):
Front overview:
A few different angle shots once more, showing flow to rest of the car.
I like how it almost look OEM as if it came out of factory but still have a sporty feel to it.
Front view:
Lower angle (Lexus emblem was removed in favor of Griffin
):Side view with different angles, showing how the lip flows with 97＋side skirts (please disregard the 4x4 fender gap, I'm getting Tein coilovers this week.
):A close up of trimmed/shortened end of lip (please refer to previous post with picture for reference.):
Smooth transition from lip to bumper while retaining character line:
Fogs light edges cleaned up:
More molding (I didn't do a good job on wiping water off
):Driver's side:
Close up:
Driver's side side view (there's a French bulldog in the reflection
):Front overview:
A few different angle shots once more, showing flow to rest of the car.
I like how it almost look OEM as if it came out of factory but still have a sporty feel to it.
12-28-11, 05:21 PM
#73
Lexus Champion
iTrader: (8)
Join Date: Dec 2003
Location: California
Posts: 2,605
Likes: 0
Received 0 Likes
on
0 Posts
I did, i honestly thought it would fit a lot better than it did. It's obviously too long on one side and will require some trimming as posted earlier. But overall looks pretty good, I didn't have it professionally fitted/trimmed and basically put it on the way it came.
Here's a pic
Here's a pic
