97-SC300

iTrader: (17)

That's sick ^^

Was it difficult to mount? Or just drill a bunch of holes?

pishta

I fixed my F'n driver door that wouldnt open. I think my kid hit the power lock when I had the door handle up or something because the lock mechanism went sort of half way between and the door wouldnt open from inside or outside. I thought I lost a rod but turns out it was much simpler. I just manually cycled the doorlock firmly in both directions and it eventually jumped back into operation and both door handles work now, but this was after I took apart the passenger door to see how it worked and then almost ripping the driver door panel out because I could only get to the handle and armrest screws. Ill write it up in another post.

KahnBB6

iTrader: (5)

Replaced the original injectors with remans. Swapped back my original ECU for testing.

SC2JZ300

iTrader: (8)

Not at all, it helps with two people but definently manageable if your doing it yourself. All i did was drill the holes, and screwed them in to the underside of the stock side skirts. I will say if you go after this method to start from the middle and work your way out.
Starting with mounts on the side ended up with a wavy outcome. Splitters now sit flush and look esthetically pleasing

MrCJ305

Got my exhaust installed finally

ems

iTrader: (1)

drank a coffee with the car, we talked about its upcoming procedures.

GISguy

This. Thank you to Tabaka for the decals!

ems

iTrader: (1)

did you clear over them?

pishta

I took the dark needles out of my dash and used "Electric Paint" at $11.00 a tube to try and bridge all the open circuits in the LED lighting along the edges. They all were completely dark, not even a flicker and now I resurrected about 25% of the LEDs in the needles, Enough to actually see their positions at night. I was hoping for 100% but it just wasnt happening. Every one had an open right off the pin socket. FWIW, the operating voltage of the needles is 5V. Ill write it up in another post.

weeters

iTrader: (1)

Tinted windshield 35% carbon black. Tinted headlamps and fogs.

N1T3MARE

iTrader: (2)

Walked by my SC and looked at in in disgust, since it isn't running well, and hopped in the GS to go to a family lunch.

SC2JZ300

iTrader: (8)

Posted Up Outside of Marlow's For Brunch

pishta

drove to church this morning and my friggin air bag light wouldnt go off, WTF?

net4n6

iTrader: (1)

I dropped it off at the body shop for a full paint job. The man at the body shop was surprised how nice and clean the car was. There wasn't ONE ding on the car. The clear coat started to "crack" on the hood and front bumper. It bothered me every time I drive the car. The man was surprised that I wanted to paint the car.

LEXXIUM

iTrader: (1)

Ok, after installing the ls400 bbks with the extended lug nuts and 20mm hub centric spacers, also lowered it on stock shocks, with abs and track deleted my bro Lex_man came over and helped me bleed my brake system, and the ride is back on 4 wheels after 4long weeks
Just cleaned up the garage and it's gotten dark. I'm done for today
Thanks bro!!!