What did you do to your SC today?
04-18-14, 11:03 PM
#4308
Lexus Champion
put the IS300 wheel on! it's soooo much better!!!! actually feels like a sports car and not a grandpa mobile. also resealed the headlights, now have to wait for a moist day to see if they're sealed properly now and won't fog up again.
04-19-14, 12:15 AM
#4309
Lead Lap
iTrader: (1)
Join Date: Feb 2008
Location: I.E Southern California to SA,Texas
Posts: 4,447
Likes: 0
Received 5 Likes
on
5 Posts
After a few months of owning the new to me SC finally clay bar it....later will polish and wax. It made a noticeable difference it still needs a respray but its not too bad and looks ok. Also removed the old 90s style painted pin stripe that ran down the sides. 
[/IMG]
04-20-14, 11:36 AM
#4314
Re-installed the hood liner (after rinsing out all of the coolant). Had to swing by the dealership to get some of the plastic holders since I broke a few getting it out.... $1.50 each for a 2cent piece of plastic but as least they had them......
04-20-14, 11:46 AM
#4315
A glorious day!
I took the Hard as a rock Blizzak run flats and heavy assed SC430 wheels off and put them in storage.
I put the Work summer wheels back on, semi-slammed it and had it aligned.
Unrelated side project....
(Slow cooked a badassed spicy 9 pound Pernil, a veal loaf with prosciutto and fresh mozzarella, cauliflower (fake) mashed potatoes and 2 salads)
Low car
Low carb
I took the Hard as a rock Blizzak run flats and heavy assed SC430 wheels off and put them in storage.
I put the Work summer wheels back on, semi-slammed it and had it aligned.
Unrelated side project....
(Slow cooked a badassed spicy 9 pound Pernil, a veal loaf with prosciutto and fresh mozzarella, cauliflower (fake) mashed potatoes and 2 salads)
Low car
Low carb
04-20-14, 03:46 PM
#4318
Removed the valve covers in order to install new gaskets and to stop oil hemorrhaging. The valve cover bolts were a little more than finger tight. Of course I'll have to replace a number of rock hard hoses now as well. After I removed the throttle body, I noted that it is coked up badly. Should I bite the bullet and remove the kegger and intake manifolds now and give a good bath, or can I wait for a little while? Gasket set is only $23.00. Never had the kegger and intake manifolds off. is this a big deal? 
04-20-14, 04:38 PM
#4319
Rookie
Join Date: Aug 2013
Location: wa
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Cleaned some nooks and crannies. Regina will be in a judged car show next month so I making a small effort to clean her up. Drove her to the Italian car show in Issaquah. She was the nicest non-Italian car in the parking lot. Drove her to the wealthy city of Bellevue for lunch. She was the nicest car in the parking garage. Drove her to an open house in a new housing development near Bothell. She was the nicest car in the neighborhood. See the pattern here. I'm not bragging. She's a nice car. Thank you to the previous owners that made this possible.
04-20-14, 06:44 PM
#4320
Driver School Candidate
iTrader: (1)
Join Date: Mar 2014
Location: FL
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Put new taillights in so my light would go off on dash. Lol. The lense was cracked on old ones allowing moisture to cause rust on sockets. Next up is headlights!