When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
my very very first rice mod, I think it's a rice mod, because I have a 1uz with almost 200k under the hood and I'm slowly prepping this chassis for a 2jz na-t swap this is a very cheap mod at least it will measure vaccum for right now, until the swap time still need fuel system and wiring done.
came up with some ideas for a boostgauge install $5 universal pod from summit trimmed with 26$ Bosch gauge and attatched to the a pillar gangsta style, the other option was a piece of aluminum cut, trimmed, bent, wrapped and it still needs bent more to fit the bottom of my stereo curve.
That's what I did today
I was thinking about spraying the screws black or just use black plastic clips, but screws are stronger I'll try to even it all out
Could you do something where the upper part screws directly to the "oh ****!" handle's mount, requiring less wrap-around down lower? I shaved my mounts halfway down so they sit flush sans the handles, and still hold the A-pillars snug. Then you could use a dab of double-sided tape to keep the lower end from wanting to twist from gravity and vibrations.
It won't match up with the contoure of the pillar and would be crooked and too high up, I don't have **** handles anymore, there will be a piece of 1/4" think aluminum strips bolted on instead to hold the pillar snug in place, but not worried 😩
Finished installing the DM power steering line, was harder to manipulate than I expected but it's on there. Also going to look into getting a ps cooler
Do you happen to have a soundclip of your new setup? I was contemplating on removing the three resonators after the axle-back I did seemed a bit too underwhelming.
Originally Posted by duster
Deleted 3 resonators. Definitely breathing better, more responsive and sounding better. Kept the stock mufflers. I used a flashlight to try to show how small the pipe gets right before the first resonator.
01-30-17, 07:06 PM
