Fender removal DIY
#20
Driver School Candidate
Join Date: Oct 2010
Location: California
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
I knew someone else was going to ask the rotor question. They look nice, but looks like its been dragged on rotors.
My buddy had his 300zx stolen and they took the rims and this exact thing happened to his rotors. All I could think of as a possibility now. lol
My buddy had his 300zx stolen and they took the rims and this exact thing happened to his rotors. All I could think of as a possibility now. lol
#28
Driver School Candidate
Still a helpful thread a few years later.
I just removed my fender due to the paint peeling and metal rusting on the top. I removed it with the wheel on since that is what I will need to do in the salvage yard where I am getting a replacement fender. I may need to fend off a few rats in the salvage yard when I'm removing that fender.
Here's a pic of all of the bolts, screws and nuts I had to remove to get the passenger side fender off. It took me about an hour with minor distractions. The wrenches are all 10mm. The screw in the bottom left corner is the only one I had to remove from the fender lip.
I just removed my fender due to the paint peeling and metal rusting on the top. I removed it with the wheel on since that is what I will need to do in the salvage yard where I am getting a replacement fender. I may need to fend off a few rats in the salvage yard when I'm removing that fender.
Here's a pic of all of the bolts, screws and nuts I had to remove to get the passenger side fender off. It took me about an hour with minor distractions. The wrenches are all 10mm. The screw in the bottom left corner is the only one I had to remove from the fender lip.
Last edited by DrewL; 07-11-15 at 07:22 AM.
The following users liked this post:
spuds (01-12-20)