When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
you have instructions from a different viper model. I have the 5706v yours is the 5901
I have a
10 pin
24 pin
and a 6 pin
Now I see why you got different instructions, lmaol. I assumed you had the 5901 since this thread is about the 5901.
I am sorry Jim, I doubt I can be of further help since I don't have experience on the 5706v. A wrong advice from my end can cause damage and even set your car on fire since those wires you are asking about are high amperage wires.
Go to my build page and start on page 22. The viper alarm you are installing is built by DEI which is what I installed. Most of your wire locations and matching wires can be found on pages 22-24
Go to my build page and start on page 22. The viper alarm you are installing is built by DEI which is what I installed. Most of your wire locations and matching wires can be found on pages 22-24
Shane
okay cool, thanks shane. did you or g happen to use a relay? when I call best buy or any other shop they say "you need a relay' but I see other threads where it's not needed?
Jim - I used a relay for the trunk release.... but relay is not going through ignition so trunk can be opened by the remote without key on the ignition.
Jim - I used a relay for the trunk release.... but relay is not going through ignition so trunk can be opened by the remote without key on the ignition.
so to make that work, would I need to run the trunk trigger or trunk release output?
1.)im starting to think this damn wire does not exist....lol...i found one wire that was green with lil grey tac marks on it...and they flashed on with the unlock/lock feature ....when i turned the car on they didnt stay on.. then i found a green and yellow wire and a green and black wire..green and black the left signals front and rear flashed green and yelloe the right signals flashed...tried both together fuse blew lol....idk....
Easiest place to tap on the tach is from the connectors / wires near the ECU or from the igniter .
The trunk trigger is tapped on a wire on the driver side running board. It is a wire that goes to the release solenoid of the trunk. If I remember right on the SC it is a red / white wire...
12-27-15, 06:53 AM
