has anyone ever changed a rear quarter
#1
Driver School Candidate
Thread Starter
Join Date: Nov 2009
Location: Fl
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
has anyone ever changed a rear quarter
on an SC3 SC4? Im thinkin about pickin up an sc4 that needs a rear quarter. i have an sc3 shell in my driveway with a good panel so getting it isnt the hard part removal of both and reinstallion is the hard part. if anyone has done this before any info would be great, thanks
#5
Driver School Candidate
Thread Starter
Join Date: Nov 2009
Location: Fl
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
ya i know its a tough job i have a friend whos a good welder but other than that im about on my own. i would swap it all over to my car but i chopped all the harness's when pulling parts as i had full intentions of sending the shell to the scrap yard
#6
Pole Position
iTrader: (4)
Join Date: Feb 2009
Location: MA
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
DON'T DO IT. replace engine, harness, fender, door, ----not qp. 1 mistake by a body shop and you're screwed. I doubt any of the guys that did extensive work on their car would consider this.. there's probably 101 reasons.
Thread
Thread Starter
Forum
Replies
Last Post
shenry500
IS - 2nd Gen (2006-2013)
6
10-02-12 10:00 PM