Ace9282

Ok so im about to put my built engine and TH400 swap into an sc300. Looking for some vetrans at this.

A) what do i do about a trans mount?
B) how should i go about a drive shaft?


thanks for any info

LSEGHATCH

There is a th400 for sale in the sc300 classifieds. He'd probably know.

Dx3

iTrader: (13)

I had a TH400 in my SC300. I know you need a custom driveshaft but don't remember what trans mount was used...

Contact Boostlogic.

Jonny

turbodremz

iTrader: (18)

PM Hyjaxx, she has had hers mounted in for some time now..look through her thread too, tons of info there

redline808

I have been searching for hours now, but more specifically about tunnel clearance. I have read, that it fits with the gm bell housing and adapter plate, I have read that it does not fit and you have to pound the tunnel, I have also read that if using a toyota bell housing no tunnel modification is necessary. can anyone chime in on what is true.

Thanks.

fishhead

Mine had to be modified even with the toyota bellhousing. Mostly around the shift linkage. With the gm bellhousing a lot more clearancing is needed though.

1siksc

iTrader: (8)

http://www.atfbilletparts.com/transm...-adapter-p-251
all you need is a bunch of adapters, torque converter adapter, bellhousing adapter, kick down electronic conversion, speed sensor electronic conversion, new shifter or some kind of conversion, trans mount adapter

BoostedVic

just wondering , im doing a th400 swap, what issues will i get with the stock ecu as far as it not seeing the stock trans anymore ? any codes, or non startup problems

Highway

Some very good info in here!

ar3

My family friend has an atfspeed th400 adapter for sale. He ran a th400 on his SC NA-T. PM me if you want