license plate frames...ideas...
#2
Lexus Fanatic
iTrader: (1)
I went with quality polished 2 hole thin stainless steel for the front and a black powdercoated thin stainless steel 2 hole for the front.I went with black because of the black plate holder.I had the same frames on my last RX.I put them on the '10.
Screw covers are chrome and black to match.
I buy my frames from here...
http://www.autoattire.com/stainless-...te-frames.html
Screw covers are chrome and black to match.
I buy my frames from here...
http://www.autoattire.com/stainless-...te-frames.html
Last edited by Joeb427; 12-17-10 at 09:33 AM.
#3
No, I don't play soccer!
I went with Prestige with the glass cover which is replaceable. The frames are thick and stick out a bit but I like the quality. And they're not kidding when they say it takes 15 minutes to install them.
http://www.autoanything.com/licensep...A1370A0A0.aspx
http://www.autoanything.com/licensep...A1370A0A0.aspx
#4
Moderator
Join Date: Aug 2006
Location: San Francisco, CA
Posts: 12,041
Likes: 0
Received 69 Likes
on
42 Posts
I had the good ol' LEXUS frame for the rear and the dealer plate on the front on my old RX.
it looked like this:
on my new RX, the dealer plates actually look pretty nice so I think Ill hold onto them.
it looked like this:
on my new RX, the dealer plates actually look pretty nice so I think Ill hold onto them.
Thread
Thread Starter
Forum
Replies
Last Post