neew help,wipe trans and blade rplacement
#1
Driver School Candidate
Thread Starter
Join Date: Oct 2012
Location: nj
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
neew help,wipe trans and blade rplacement
Hello,i'm new here,I have an issue with my rx 350 2007 1/2..I replaced the wiper transmission and wiper arms ,but i cant get the arms to rest in the lower pos..they stop in the middle of the windshield..is the issue with the arms ,or in the trans when i remounted the motor..or is there a trick im missing
Last edited by liljohn30; 10-23-12 at 01:47 PM.
#3
The problem is with your installation of the arms most likely. I would take the arms off. Start the motor and turn on your wipers as you normall would, then turn off. At this point the arms should be able to be installed at the lowest most position.
#5
If you can remove the arms, and start the wipers (motor) then stop it, I would assume that you will be in teh 'rest' position. The passenger arm then goes on where the end of the wiper (outside) faces a little mark visible at the base of the windshield. The driver's side arm faces between two marks low down on the windshield. You should then be 'adjusted' correctly.
Otherwise, maybe that, when the wipers are 'stopped', you can dismount the arms and re-mount them in the correct (horizontal/rest) position?
#7
Driver School Candidate
Thread Starter
Join Date: Oct 2012
Location: nj
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
update,i got it figured out,i found a web site were all u need is a libary card and u can view any chilton manuel is exsistance..loli didnt have the gear and motor mount lined up exactly...
Thread
Thread Starter
Forum
Replies
Last Post
numbafree
RX - 2nd Gen (2004-2009)
0
01-31-18 06:55 PM
capz1121
RX - 1st Gen (1999-2003)
1
04-17-13 08:02 AM