RX - 2nd Gen (2004-2009) Discussion topics related to the 2004 -2009 RX330, RX350 and RX400H models

2006 RX 330 Radiator Leak

Old 11-06-09, 08:27 AM
  #1  
tom8757
Driver School Candidate
Thread Starter
 
tom8757's Avatar
 
Join Date: Aug 2008
Location: Calif
Posts: 29
Likes: 0
Received 0 Likes on 0 Posts
Default 2006 RX 330 Radiator Leak

I have a 2006 RX 330 with 108,000 miles. The radiator is leaking at the top passenger side. I have the 100,000 mile lexus warranty that just ran up. I brought it to the dealer because I have had 5 Lexus autos and never had this problem.

The dealer wants almost $1,000 to do it. I found a radiator shop that will do it for $400 but they say the entire radiator is Aluminum.
The other radiator shop said about $440 and it has plastic tanks.

Can I do it myself?

What do you suggest I do?????

Tom
Old 11-06-09, 11:15 AM
  #2  
Iqraam
Pole Position
 
Iqraam's Avatar
 
Join Date: Apr 2009
Location: CA
Posts: 286
Likes: 0
Received 0 Likes on 0 Posts
Default

That sucks man...i have an 05 and just had my radiator replaced a few weeks ago with the same problem. I dont know if it is an easy DIY project but I would definately stick with aluminum since thats what our OEM is. Hope you have the best of luck if you do decide to do it yourself.
Old 11-06-09, 11:37 AM
  #3  
968racer
Driver
 
968racer's Avatar
 
Join Date: Apr 2009
Location: WI
Posts: 164
Likes: 0
Received 0 Likes on 0 Posts
Default

I was just about to recommend you to DIY until I looked at the cost of a new radiator from AutoZone, $377 with out the towing package & $392 with. $400 doesn't seem so bad to have someone do it.
If you can find a radiator for about $200, my suggestion, DIY if you have some basic metric wrenches/sockets. You'll only need new coolant, unless it was recently replaced (make sure it's compatible with our cars) distilled water & a new radiator. Your hoses should still be good. I've replaced radiators in a 3 cars and it was pretty easy. I can't imagine the RX would be any more difficult. It took about 3 hours each time I did it with taking my time. There seems to be a good amount of room to work in the engine compartment too. I would get a Haynes manual so you can locate the screws that hold the radiator (Probably 3 or 4 of them) and the drain plug for the coolant. Basically, drain coolant, remove hoses, remove radiator, install radiator, reattach hoses, refill with coolant with the car running and heat at full blast. There may be a sensor on the radiator too. I'm may be missing something but it's pretty basic. The $25 Haynes manual is definitely worth it. I would rate this DIY slightly more complex than doing your brakes.
I can check my Haynes manual this weekend to see if there are any gotchas if you'd like. I don't think we need to bleed these cooling systems of air but can check that too.
Old 11-07-09, 04:12 AM
  #4  
veleno
Lead Lap
iTrader: (3)
 
veleno's Avatar
 
Join Date: Jun 2009
Location: 671
Posts: 634
Likes: 0
Received 1 Like on 1 Post
Default

Have you considered non OEM radiators? They are cheaper for sure and do the same thing. While it's always nice buying OEM parts because it provides peace of mind and exact fit, it's not always the most affordable.

Call around and get prices. As of recently, I've seen more vendors pushing the "Mishimoto" radiators. I'm not sure if they make one for your car but it doesn't hurt to check.

If it's $400 for everything (aluminum radiator, materials, labor) then it might be better to have that shop do it. If it's anything more then hello to DIY. Like mentioned above it's not hard to do, pretty straight forward once you seen what connects where.
Old 11-07-09, 05:09 AM
  #5  
kiwi
Lead Lap
 
kiwi's Avatar
 
Join Date: Jul 2009
Location: Montreal, QC
Posts: 669
Likes: 0
Received 2 Likes on 2 Posts
Default

if you are going to do it yourself i would investigate if the condenser has to be pulled, more than likely it doesnt, but if it does then you will have to get a shop to do it for you.
Old 11-07-09, 08:27 AM
  #6  
968racer
Driver
 
968racer's Avatar
 
Join Date: Apr 2009
Location: WI
Posts: 164
Likes: 0
Received 0 Likes on 0 Posts
Default

I just checked the repair manual. No need to remove the condenser on 04 & later models. You do need to disconnect the transaxle oil cooler lines but not very much fluid should escape. You would just want to check the level if you feel too much was lost. You will also need to remove the shroud fan, no biggie.
Old 11-07-09, 09:42 AM
  #7  
tom8757
Driver School Candidate
Thread Starter
 
tom8757's Avatar
 
Join Date: Aug 2008
Location: Calif
Posts: 29
Likes: 0
Received 0 Likes on 0 Posts
Default Radiator

I was told that on a 2006 that the air conditioning condesor has to be taken off and so I need to recharge the air conditioner. Has anyony heard whether thats true?

I really appreciate everyones suggestions. Times are tough and i am trying to do it for the least i can.

Tom
Old 11-07-09, 05:40 PM
  #8  
968racer
Driver
 
968racer's Avatar
 
Join Date: Apr 2009
Location: WI
Posts: 164
Likes: 0
Received 0 Likes on 0 Posts
Default

If the Haynes manual is correct, you wouldn't need to remove the AC condenser.
Old 11-08-09, 04:53 AM
  #9  
mandyfig
Moderator
 
mandyfig's Avatar
 
Join Date: Apr 2007
Location: GA
Posts: 12,298
Received 407 Likes on 359 Posts
Default

Let a shop do it, at least you have warranty.

But I would suggest further negotiations with the dealer. They should give you a break. You paid a lot for the extended warranty. Did you have a lot of claims? If not, they should do it for you, goodwill.
Old 03-18-11, 04:59 AM
  #10  
JamesHuang
Driver
iTrader: (1)
 
JamesHuang's Avatar
 
Join Date: Feb 2011
Location: Chicago, IL
Posts: 153
Likes: 0
Received 1 Like on 1 Post
Default

What did you end up doing? Did Lexus Corporate help you out?

Originally Posted by tom8757
I have a 2006 RX 330 with 108,000 miles. The radiator is leaking at the top passenger side. I have the 100,000 mile lexus warranty that just ran up. I brought it to the dealer because I have had 5 Lexus autos and never had this problem.
The dealer wants almost $1,000 to do it. I found a radiator shop that will do it for $400 but they say the entire radiator is Aluminum.
The other radiator shop said about $440 and it has plastic tanks.
Can I do it myself?
What do you suggest I do?????
Tom
Originally Posted by mandyfig
Let a shop do it, at least you have warranty.
But I would suggest further negotiations with the dealer. They should give you a break. You paid a lot for the extended warranty. Did you have a lot of claims? If not, they should do it for you, goodwill.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
katzjamr
Hybrid Technology
45
07-27-19 07:50 PM
sdtsdt
RX - 2nd Gen (2004-2009)
7
04-11-18 08:48 PM
DPJ
RX - 2nd Gen (2004-2009)
14
03-16-15 04:50 PM
MelYW
RX - 2nd Gen (2004-2009)
14
05-18-11 08:35 PM
Lexus 4 ME
GX - 1st Gen (2004-2009)
1
03-26-09 02:28 PM


Thread Tools
Search this Thread
Quick Reply: 2006 RX 330 Radiator Leak



All times are GMT -7. The time now is 07:15 PM.