kennylexsc

any one can help me to stop the indicator light blinking after doing oil change myself on RX 330 and ES 330?

thank you

CC05RX330

I believe you hold down the odometer switch then turn ignition to on then wait for dashes in odometer to disappear.

Rainbird

Make sure the odometer is set to total miles not trip. With the key in the off position, push in and hold the odometer reset button (ODO). Turn the key to the on position without starting the car. Continue to hold in the odometer reset button until the maintenance required light goes off (about 20 seconds).

Orzel

iTrader: (1)

There have been a few threads in regards to this. Set your odometer readout to miles (not trip miles), turn off ignition, holding in the set button, turn ignition to on (not start) and wait for the odo reading dashes to go away. That should do the reset.