andreys

Just out of curiosity, has anyone re-wired the fuse box to allow power outlets be on all the time? And if so, what are the steps?

I did re-wire mod in my 4Runner, but can't locate the same power outlet relay on RX330. Here is the info regarding the 4Runner:

http://www.yotatech.com/f127/full-ti...4runner-75183/

- Andrey

silvervett

I was dissapointed to discover my outlet didn't work when I turned off the key so I am giving this topic a bump up to the top.

I have a Coleman electric cooler that I would like to keep on when I turn off the key, and my Garmin GPS re-boots every time I stop for gas.

mandyfig

Is your Garmin plugged? My Mio goes to internal power when I shut down the power. So, it is on all the time, until I turn it off. Or the internal battery shuts down if in need of charging.

Lil4X

Be careful about this because I managed to completely drain my battery when I accidentally left a large Li-ion battery charger on while I took a nap. Killed the battery in about an hour, I did! Maybe it is a good idea to have everything go off with the key when you get out of the car. (I'd left the key on . . . D'oh!)

andreys

how did you manage to leave the charger on if power outlets go off?

AM1

iTrader: (6)

yes how did tht happen?

salimshah

I read the post as engine OFF but the key in ACC [power on].

Not knowing the wiring, the easiest solution is to

existing + wire [ cut and put a series diode P, other end N] -> CigLighterCenter
+ from the battery [series new fuse] -------------------------| (merge up)

The idea is to merge direct 12v with a protection diode in existing to prevent back flow.

Salim

silvervett

The Garmin SP 7500 does not have a battery. The 2003 Jeep Grand Cherokee I just sold gave you an option. It had about 5 or 6 plugs with two in the front. One plug stayed on with the key turned off and the other one shut down, I don't remember what the other plugs did.

Lil4X

Sitting at the wheel on a remote location, I sat in the car during a long break, starting and idling the engine for fifteen minute intervals to top up the batteries charging on the 110v port. At some point I turned off the engine, but I failed to rotate the key fully to the "off" position. Ordinarily that would be no problem, but the inverter was powering a charger with five large (dead) Li-Ion batteries attached. I'd been up for about 30 hours at this point and went to sleep for about an hour while my battery packs continued to charge.

I plan not to do that again, but a heavy power demand with the engine off could leave you stranded somewhere. Powering the inverter directly from the battery would make it even easier to make this mistake. I am looking a purchasing a large capacity inverter to run separately that incorporates an automatic shut-down should the vehicle battery run too low.

122669GX

I installed the jumper wire in the attached link but after about a week both the cg lighter and the accessories port ceased to function. I checked the fuses and both are good does anyone know if an other inline relay may have been damaged?
http://www.***********.com/ja/2007/12vpower.html

thomas1

Funny ford has always allowed a hot circuit with ignition off. My battery in the F150 is 8 1/2 years old and has never had a problem, granted it is a huge battery...But the real culprit above was leaving the ignition in the accessory position which keeps a lot of things alive.

drewcam888

iTrader: (1)

Where did you find the relay in your rx?