99 RX300 keeps blowing AC and INT fuses
#1
Driver School Candidate
Thread Starter
Join Date: May 2013
Location: NJ
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
99 RX300 AC Blower no loger working
My 99 RX300 recently blew a fuse for the AC blower so I replaced it. It worked for a day then stopped. I tried another fuse, but now it will not come on at all.
Is there a realy someplace that I can change or am I looking at going under the dash and swapping out the blower motor or blower control unit ?
Thanks, Chet
Is there a realy someplace that I can change or am I looking at going under the dash and swapping out the blower motor or blower control unit ?
Thanks, Chet
Last edited by greenRX300; 08-25-13 at 05:11 PM. Reason: Subject changed
#2
Driver School Candidate
Thread Starter
Join Date: May 2013
Location: NJ
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Well I found the solution to the AC blower not working. It ended up being the Blower motor control module. Pretty easy to change, 1 screw and a plug is all that holds it in place. Its kind of nestled behind some of the duct servos and other stuff so you need to wiggle it a bit to get it out. They are however expensive ($126 to $300) depending on where you shop. I scored a used Denso one for $75 from ebay that worked just fine though.
Chet
Chet
#3
Moderator
Thank you for sharing.
The controller is not hermetically sealed. When mine blew out ... I lost control of the speed. I looked at some pictures of the controllers being sold on the bay and decided to pony up for a new one.
It seems like a part that fails after number of years.
Salim
The controller is not hermetically sealed. When mine blew out ... I lost control of the speed. I looked at some pictures of the controllers being sold on the bay and decided to pony up for a new one.
It seems like a part that fails after number of years.
Salim
Thread
Thread Starter
Forum
Replies
Last Post