JBDUFFY1

I have a 1999 rx300. Changes front driverside no issue. Went to rear and the top of the caliper where I thought would be a bolt head (Front has top and bottom bolts). There is no bolt head. I climbed under car and looked at opposit side. It looks as if on passenger side the top of the caliper (Where a bolt should be?) has no head either. We never di thid before and I was looking for pictures of rear caliper to see. But did someone snap off the bolt heads on the tops? The bottom caliper bolt is on each side.

I am going to do front passenger side first while people anser.

HELP!!!! Pictures!!!

Jim Duffy

thomas1

That is correct, there is only one b olt on the bottom, the upper is a pin. (Rear brakes only) The caliper slips off the pin.

carguy07

https://www.clublexus.com/forums/rx-...-pads-diy.html

JBDUFFY1

Front was piece of cake....couldn't get rotor off rear but they were not bad . Now I have to rear rotors that are brand new for the rear. But want to know how for future

mikey00

There are 2 bolt holes in each rotor. These are so you can insert 2 bolts which will push off the rotor. Also make sure your e brake shoes are not adjusted tight and holding on the rear rotor.