Lexmex

And the rear again after the primer.

Lexmex

And this is how it will look until we paint it.

sgv_bum

nicely done .. looks good but look way better when its painted

Lexmex

I looked carefully at my HyperRev magazines, but didn't see any other areas (I looked at the rear reflectors on lower bumper) that needed trimming. Probably next photos will only show the end result, because I will be at work on Monday while they finish up the paint job.

TampRX300

looking good. Pay attention real well so when you come to tampa........ LOL

miniround

I feel as if it's taken me longer to read through the pics and captions than it took to do the job AND upload the thread! haha!

well very cool, Lex...can't wait to see the end result.

p.s. you only sanded the bumpers because you were repainting them as a whole, right?! you didnt sand off any lines or grooves to change the look, right?

Lexmex

That's right. Lines are the same, but I had some torn up pieces of the bumpers due to hits, so we are repainting the whole things.

New update, we won't be getting back to work on painting the bumpers until Thursday morning. This is in part due to some logistics my uncle and I worked out.

zombie

iTrader: (1)

nicely done!

Lexmex

Still a work in progress at this point, but by Friday we should be done. We decided to add another layer of protection in places, so Gilberto went to work on it this afternoon.

Lexmex

We went around and looked for every last chip, even minor, in areas.

Lexmex

We also begun adding tape and newspaper to prepare for tomorrow's painting.

Lexmex

And added some more layers of primer

Lexmex

And some more protection on the front.

Lexmex

And even smoothed down the lines on the side of the bumpers.

Lexmex

And we even covered up the holes on the front bumper. Keep in mind my home state of Florida does not use a front plate, but my vehicle was once a DC, VA and NY vehicle, all of which use front plates.